Box, look alright?

[hockey512546]

This box is for a Fi SSD 12, around 2.2 @33Hz
46.5 sq" of port area and about 46.75" long
Does this look alright/ will it work? This is the first box I've designed
In particular, will the short bend in the port inside the box work out?

[Digital Designs]

Arent the corners of the port gonna mess it up? You should make the port the same width all the way throughout, and those corners will make it smaller there.

[bubbagumper6]

looks ok to me...

[bubbagumper6]

Arent the corners of the port gonna mess it up? You should make the port the same width all the way throughout, and those corners will make it smaller there.

you fail geometry? Those braces are in there to so that it WILL be a uniform width...

[Digital Designs]

you fail geometry? Those braces are in there to so that it WILL be a uniform width...

How does that work?

EDIT...nevermind, I see it now. Either way, its not gonna be the same throughout the port unless you made them rounded.

[ciaonzo]

You are go for VBA.

[bubbagumper6]

How does that work?

EDIT...nevermind, I see it now. Either way, its not gonna be the same throughout the port unless you made them rounded.

That's true, however having those braces in there is better than nothing

[hockey512546]

How does that work?

If they weren't there that area would go from 3" wide to 4.5"
It isn't uniform through the whole corner though, that would require an arc at each corner

[Digital Designs]

If they weren't there that area would go from 3" wide to 4.5"
It isn't uniform through the whole corner though, that would require an arc at each corner

Yep, just said that in an earlier post. I dont have my thinking cap on tonight

[406er]

seams like a lot of port area, i would do a 2 or a 2.5 wide port, that think looks like 3.5 or so, it will also cut down on port length

[PsychoTheRapist]

Looks okay.. it will definitely work. Personally, I would cut down on some of the port area as to cut down on the port length. Smaller box ftw!