A Tip For Sagging PVC Aeroports

[Lakota]

Since I often times see pictures of people's aeroports sagging, I thought that I should share a little tip to keeping them sagging w/o having to us pvc cement. My team has found that short metal screws do a great job of keeping the ports tight if they are put through the coupling rings and into the port lengths. Hopefully this helps some people out.

[iamamp3pimp]

i havent seen them, but it looks like it would work great, with minimal resistance.

good work

[Lakota]

It's so minimal that it won't cause enough drag to show on the meter. I'd say that it's also a wise idea to still tape the outside of the port like normal (to seal the port off).

[audiobahnuser18]

Very nice , i used abs plastic primer & adhesive along with ductape around the port couplers.

[Lakota]

Very nice , i used abs plastic primer & adhesive along with ductape around the port couplers.

That's a great way to do it.

I just really like this method because it's less permanent.

[DBDRAGGUY]

gorilla tape FTW

[Lakota]

gorilla tape FTW

They'll even fall off with Gorilla tape, especially in the hot weather. That's the tape that I normally use.

[DBDRAGGUY]

They'll even fall off with Gorilla tape, especially in the hot weather. That's the tape that I normally use.

I usually just wrap the entire port in it, and it has not failed as of yet.

[Lakota]

I usually just wrap the entire port in it, and it has not failed as of yet.

That works, but is expensive. This method is cheap, quick, and effective. I guess the only downside is that it puts holes in the pvc and other methods don't.

[DBDRAGGUY]

That works, but is expensive. This method is cheap, quick, and effective. I guess the only downside is that it puts holes in the pvc and other methods don't.

I think you have a good idea,that will work just as well.

I may try it out.

[18inchjeepin]

i too suffer from sagging ports



i think i will try this next week

[basshedz06]

i suffer also i will give this a try before my show tomorrow