Closed Thread
Results 1 to 3 of 3

Reload Thread: Working with Vinyl

  1. #1
    Webman33569's Avatar
    Webman33569 is offline Member



    Join Date
    Dec 2008
    Location
    Ocean Side, CA
    Posts
    42
    Post Thanks / Like
    Mentioned
    0 Post(s)

    Working with Vinyl

    Can anyone give some advice on how to work with vinyl and get it to look good. I have tried a couple times in the past and it always turned out like crap. The vinyl was loose or something. Also im trying to design a setup for my mustang with 2 12's but i dont have the dementions of the trunk. If anyone who reads this has a 05 or later mustang and can get me the dementions i would be greatful. I would search the web to try to find it out but the network im on blocks to much stuff.







  2. #2
    Join Date
    Nov 2008
    Location
    Owensboro KY
    Posts
    84
    Post Thanks / Like
    Mentioned
    0 Post(s)

    Re: Working with Vinyl

    Never worked with it before but I've always heard that if you heat it up it makes it easier to stretch out and that the surface your applying it to has to be perfectly smooth as it shows even the tiniest imperfections. Good Luck.




  3. #3
    ramos's Avatar
    ramos is offline Still learning



    Join Date
    Dec 2001
    Location
    Virginia
    Age
    49
    Posts
    10,315
    Post Thanks / Like
    Images
    8
    Mentioned
    6 Post(s)

    Re: Working with Vinyl

    Good glue , lots of it, a heat gun/ hair dryer makes stretching easier, and an arse load of patience.



    5 % equipment
    90 % install
    5% beer

Closed Thread

Posting Permissions

  • You may not post new threads
  • You may post replies
  • You may post attachments
  • You may edit your posts

1e2 Forum