Bracing and Aero port..

[miker]

Alright.. I'm doing a 25"x6" Aero... (other size suggestions are welcome) for a 2.5cube box @ 32hz..

Soo.. How will I brace the port? I think it will need more support than just at the hole it goes through..

[BrianChia]

Duct tape and guy wires?

Or you could box off a square section around the port made of MDF to support it.

[Abel]

this box just wont work 2.5 cubs and tuning that low just doesnt add up you would need 55" straight lenght to tune that low. i Suggest building a bigger box. What type of car and subs you using?

[WrenchGuy]

this box just wont work 2.5 cubs and tuning that low just doesnt add up you would need 55" straight lenght to tune that low. i Suggest building a bigger box. What type of car and subs you using?

I was like huh my 2 cube at 43 is a 4" port

[Abel]

Forget what i said before i thought you were going to run 2 ports instead of 1. i still suggest a bigger box

[miker]

this box just wont work 2.5 cubs and tuning that low just doesnt add up you would need 55" straight lenght to tune that low. i Suggest building a bigger box. What type of car and subs you using?

Well, thats what Brian told me.

Alpine Type R 12", BMW 325ix.

[BrianChia]

That's the correct length. 25 1/4" should be almost dead on 32 hz.

[bjfish11]

According to the psp-inc calculator. 2.5 @ 32 hz and one 6" aero, needs 26.38" of length. So yea you are really close. 25.25" will get you a tuning of around 32.6, according to their calc.

[Skip01]

Yehh thatll work

Make some wood thing to rest the port on

[miker]

Yehh thatll work

Make some wood thing to rest the port on

Like a saddle? thats a good idea.