box.... idk if dim's are proper?

[more_spl]

My first ported box, and wanna make sure this goes right.

I am planning on on 3Cubes, slot ported, tuned @ 28hZ....
i didn't know if my LxWxH where in the right place.. is my diagram correct?

and the
H: 8"
w: 2"
L: 14"

would tune me to 28hZ right??

this is box could possible be for a Shiva if that matters... I know more xmax you are supposed to keep vent more "square".... is the 4:1 ratio square enoug.....

THanks

[ss3079]

Didnt we just figure this out?

- Steve:p

[more_spl]

Yes..... but my Question here really was are my L-W-H in the right area? I know some people switch them around and all.... i never asked you that

[packerfan]

Ah i would make it atleast 3 in wide to reduce port turbulance.

[more_spl]

thanks.... i updated my plan..


Box Outside Dimensions.
Height: 15.5”
Length: 23”
Depth: 17”

Port Dimensions.
Height: 5.5”
Length: 3”
Depth: 14”

Tuned: 29hZ
Ft^3: 2.7 (not including custom fiberglass top, ~2.8 after)


******The 5.5x3 will be good eh?