new 12" Kicker L7 box pics. First box build
Well, finally finished the box. No pics of the actual build up, was doing it in shop class and they don't allow electronics.
First pic is after half a coat of spray primer, then I ran out. Probably didn't need it anyway. Next pic is after 1 coat of Gray Rustoleum Hammered brush on paint. Next pics are of it with the sub and amp mounted. Still have to silicone the speaker wires. I know I know, 8ga is unnecessary, but I had it sitting around, and it's all Raptor but one length and good for nothing else anyway. Last pic is the new box next to the old. Pretty big difference, huh?
So, opinions? I should have countersunk the screws more and filled the holes with putty, but I had too many other things that needed to be made. It'll have a couple blue neons inside shining out the port to match the amp. Korny I know,but I wanted to do it It's built to kicker specs out of the tech manual. 3.25 cubes at 37HZ.
Don't have it hooked up yet. My truck's down for a while while i'm installing a new clutch. Hopefully i'll have it back by Sat
Last edited by budget76; 10-02-2007 at 10:49 PM.
PAST: 1976 International Scout. JVC head unit, pioneer 6x9's, Focal 5.25 comps, and a Kicker S12L7 in 3.25 cubes at 37hz: Crunch PZI 1500.1 amp at 1 ohm. 1/0 throughout.
Replaced the factory 8 track and single 4x7 speaker behind the dash
PRESENT: 95 325TI. JVC HU, 5.25" PG RSD, Sony Xplod 604EQX 4ch built in EQ, 10" MB Quart Discus in custom molded 'glass enclosure
Refs: JLJunkieMX107/ HawaiianBassHed/ bk12321/NightDrifter05/Annao2485/nitro_freak1/tapout/juan_caliente/fasfocus00/TheFiverMan/Louisiana_CRX