I've done some searching and didn't find anything conclusive.
What size enclosures are you guys using for the L7? Would 1.1 ft^3 each be adequate for good SQ?
Thanks guys!
CarAudio.com Veteran
Dual 12" Kicker L7 (06) sealed??
I've done some searching and didn't find anything conclusive.
What size enclosures are you guys using for the L7? Would 1.1 ft^3 each be adequate for good SQ?
Thanks guys!
CarAudio.com Elite
1.1 cu ft is too small for an L7.
I had mine in 2 cu ft 18 inches deep and it sounded much better than my previous prefab box...
CURRENT SYSTEM IN A 2007 NISSAN ALTIMA.
H/U -- Pioneer DEH-P80MP
HIGHS DOORS -- Alpine SPR-17C
HIGHS REAR PANEL -- Alpine SPR-69C
HIGHS AMP --Alpine PDX-4.150
SUBS -- 2 05 10's RESONANT ENGINEERING XXX'S
SUBS AMP -- HIFONICS CYCLOPS @ 2 OHMS = 2,900 RMS
SUB BOX -- 6 cu/ft TUNED @ 35 HZ
ELECTRICAL -- 1/0 GAUGE KICKER HYPERFLEX WIRE, BIG 3, 1 RED TOP OPTIMA UNDER THE HOOD AND YELLOW TOP OPTIMA IN THE TRUNK.
REFS: Pistons520, Sakura, MA$E, ~Magic Man~, Beerdrnkr, stuckinok, Army-Killa, James bang (x2), expo5.0, eatank, billabongcr, LuckyT, Pitbull12888, lookitsjim23, krouchchocolate, 22mountaineer.
CarAudio.com Veteran
Ok, how big was your prefab? I ordered the 2.2 cube prefab for the time being but I plan on making a fiberglass enclosure thats about 3 cubes...
Anyone else run L7s on such low volume?
CarAudio.com Elite
about 2.4 - 2.5 cubic feet sealed will do ya just fine
CarAudio.com Veteran
Well the subs are loud as ****, but naturally lack the lows in such a small enclosure. I'll be looking to make a huge box soon...
Posting Permissions
 |
Bookmarks