about how much should this trunk setup cost?
-custom plexiglass box
-custom plexiglass amp housing
-leather wrap
excluding the that little battery compartment since ill just run my amp from my starter batery
about how much should this trunk setup cost?
-custom plexiglass box
-custom plexiglass amp housing
-leather wrap
excluding the that little battery compartment since ill just run my amp from my starter batery
HEAD UNIT - Pioneer DEH-4900IB
FRONT - Pioneer REV TS-C160R 6.5 Component Speaker System
REAR - Pioneer REV TS-D681R 6x8 2-Way Speakers
Pioneer GM-6200F 4 Channel Amp
Stinger HPM Twisted 16g Speaker Wire
Stinger Bullet Series RCAs
Belkin Mini-Stereo Cable
Subs/Amp - dont know what to get
Depends on the local shop rates in your area, but it won't be cheap
I'd say close to $1k...
a thousand bucks seems ridiculous
i was thinking something like 500 or less
HEAD UNIT - Pioneer DEH-4900IB
FRONT - Pioneer REV TS-C160R 6.5 Component Speaker System
REAR - Pioneer REV TS-D681R 6x8 2-Way Speakers
Pioneer GM-6200F 4 Channel Amp
Stinger HPM Twisted 16g Speaker Wire
Stinger Bullet Series RCAs
Belkin Mini-Stereo Cable
Subs/Amp - dont know what to get
if u got the skills , u can probably make this urself with about 300 bucks in materials.

****....then i guess i need to save up some dough
i should ask around
would it be cheaper to buy the materials myself then take it to get it done?
HEAD UNIT - Pioneer DEH-4900IB
FRONT - Pioneer REV TS-C160R 6.5 Component Speaker System
REAR - Pioneer REV TS-D681R 6x8 2-Way Speakers
Pioneer GM-6200F 4 Channel Amp
Stinger HPM Twisted 16g Speaker Wire
Stinger Bullet Series RCAs
Belkin Mini-Stereo Cable
Subs/Amp - dont know what to get
www.BassHeadsENT.net for all your custom enclosure needs
Offering build service and expertise in the Tampa area as well as enclosures shipped nationwide!
Robin@BassHeadsENT.net
Check this thread for all the build logs being posted.
http://www.caraudio.com/forums/suppo...ks-thread.html
I saw a similar set up done in my local shop the other day in 2003 Lexus. They charged that guy close to 2,000 bucks for the materials and labor alone![]()
CURRENT SYSTEM IN A 2007 NISSAN ALTIMA.
H/U -- Pioneer DEH-P80MP
HIGHS DOORS -- Alpine SPR-17C
HIGHS REAR PANEL -- Alpine SPR-69C
HIGHS AMP --Alpine PDX-4.150![]()
SUBS -- 2 05 10's RESONANT ENGINEERING XXX'S
SUBS AMP -- HIFONICS CYCLOPS @ 2 OHMS = 2,900 RMS
SUB BOX -- 6 cu/ft TUNED @ 35 HZ
ELECTRICAL -- 1/0 GAUGE KICKER HYPERFLEX WIRE, BIG 3, 1 RED TOP OPTIMA UNDER THE HOOD AND YELLOW TOP OPTIMA IN THE TRUNK.
REFS: Pistons520, Sakura, MA$E, ~Magic Man~, Beerdrnkr, stuckinok, Army-Killa, James bang (x2), expo5.0, eatank, billabongcr, LuckyT, Pitbull12888, lookitsjim23, krouchchocolate, 22mountaineer.
that sounds a lot closer to what ive seen. but its really flippin clean, so you know.
im out
peace
www.BassHeadsENT.net for all your custom enclosure needs
Offering build service and expertise in the Tampa area as well as enclosures shipped nationwide!
Robin@BassHeadsENT.net
Check this thread for all the build logs being posted.
http://www.caraudio.com/forums/suppo...ks-thread.html
Bookmarks