Closed Thread
Results 1 to 1 of 1

Reload Thread: port placement

  1. #1
    nismboy6986's Avatar
    nismboy6986 is offline the **** technician



    Join Date
    Jul 2002
    Location
    Belhaven NC
    Posts
    665
    Post Thanks / Like
    Mentioned
    0 Post(s)

    port placement

    i have a enclosure that is 11x33x23.5 that the woofer mounts on top of. also there is fiberglass work that has the woofer baffle mounted like this "\" at about a 45-60 degree angle with the woofer pointing forward. I want to use 2 4" aeroports 9.5" in length but i'm wondering wheres the best place to put the port in the box. if i'm not mistaken aeroports have be half their diameter away from a wall (or twice but i hope its the first) so i was thinking of just making spacers out of 3/4 mdf and mount them firing up near the back wall of the enclosure with one close to one corner and the other close to the other corner but i was wondering if their is any better suggestions and slot port is out of the question due to space limitations,sub on top port in front wall wont work because they would fire directly in the metal of the trunk (not even a inch for the box and the metal) also the setup will be in a 03 celica which is a slant back hatchback ala GM F-body if that helps. thanks in advance for your advice
    Last edited by nismboy6986; 04-18-2006 at 05:18 PM.



    Car: '97 Crown Victoria P71
    HU: Pioneer Avic X710BT
    Front stage: want bravox CS603CF
    Front stage amp: want powerbass XTA 2240
    Substage: 15" FI BL fully loaded in 3.5 cubes @33hz firing through rear deck.
    Substage amp: Powerbass XTA 1500D




Closed Thread

Similar Threads

  1. TI-83/TI-84 Port Calculator Program
    By bcarpenterfhl in forum Enclosure Design & Construction Help
    Replies: 17
    Last Post: 05-03-2005, 08:05 PM
  2. port placement
    By jellyfish420 in forum Enclosure Design & Construction Help
    Replies: 12
    Last Post: 07-28-2004, 08:05 AM
  3. port placement??
    By cockeyed00 in forum Enclosure Design & Construction Help
    Replies: 1
    Last Post: 03-22-2004, 11:13 PM
  4. Port correction factor...
    By Vageta31 in forum Enclosure Design & Construction Help
    Replies: 5
    Last Post: 09-06-2003, 09:09 PM
  5. Port Size Differences
    By venom107 in forum Enclosure Design & Construction Help
    Replies: 9
    Last Post: 05-23-2003, 05:13 PM

Posting Permissions

  • You may not post new threads
  • You may post replies
  • You may post attachments
  • You may edit your posts
1e2 Forum