I was using a 1/2" Flush trim bit w/ bearing to trim out the port holes, but then it only cut, 1/2" of wood. I want it to trim out the whole 3/4". I was suggested to buy this 1/2" trim bit, i was wondering if i would need a 3/4" flush trim bit? Or am i trimming wrong?
also known as... LivinLife
[ References ] q-ball (kickerL5), ssackett (yellowtop), chaarlieee, Kenny Polluck (motoBTheadset), BassAddictJ, Iamamp3pimp (enclosure), lilmaniac2 (paintball gun, motors, & others), cardinalsfan (I paid half, den paid the rest), amorsh (sub), nVRuckus, LeofromtheH (amp), k4rts, rassymx, sublime0420x, lax916, ilaydit, KSilver2000, Raven, mtdewelf, SiX, KngOfThePkngLot, Dozy_production, supa_c, davidfre21, trevor87, bumpn_gt, Pistonsfav70, dbubble & moreeee!!!