hi guys, wanted to post these plans up mainly for yall to make sure my calculations were correct and of course to check my mad ACAD skillz
Ive got 2 cubes for each sub, net volume, without any bracing i might add
box total dimensions are 36" wide, 23" deep, 13.75" high, with 3/4 MDF
port area of 12.25"high*3"wide=36.75"^2 for each port
port length of 14.8" , measured from the end of the piece that splits the ports to the ends of the port walls, Is that correct??
i get a tuning freq of ~50hz which is probably kinda high, i might end up tuning down between 40-45, which would mean i will lengthen my port and increase my gross volume a little, correct??
i am open for any suggestions to make this box better