Closed Thread
Results 1 to 2 of 2

Reload Thread: problem with autopage alarm system

  1. #1
    spindrift0's Avatar
    spindrift0 is offline Junior Member



    Join Date
    Jan 2009
    Location
    San Diego
    Posts
    1
    Post Thanks / Like
    Mentioned
    0 Post(s)

    problem with autopage alarm system

    i purchase and had installed an autopage alarm system two years ago. it worked great until a month ago when the alarm started going off randomly. there aren't any apparent triggers for the alarm (no big trucks driving by or people near the car). i don't know how to stop it from going off. any suggestions?







  2. #2
    Duct Tape's Avatar
    Duct Tape is offline Junior Member



    Join Date
    Jan 2009
    Location
    South Jersey
    Posts
    8
    Post Thanks / Like
    Mentioned
    0 Post(s)

    Re: problem with autopage alarm system

    do you have a hood pin switch? it is pretty common for these to fail after a couple years. try disconnecting it if you have one.

    there should be a section in the manual where it will tell you what zone was triggered by counting the flashes on the LED after you disarm the alarm.

    other than that, i would go back to where you had it installed. you will most likely void any warranty you have if you go digging around in the wiring yourself.
    Last edited by Duct Tape; 01-08-2009 at 10:04 PM.



    50 watts per channel! babycakes!

Closed Thread

Posting Permissions

  • You may not post new threads
  • You may post replies
  • You may post attachments
  • You may edit your posts
1e2 Forum