Has Anyone done plastic molding??
I have seen a thread in a Dodge forum where a guy put a double din into his dash using plastic epoxy, a jigsaw, and a sander. Was wondering if anyone here has done plastic work and could give any advice, as the thread simply had pictures, but not necessarily a "how-to" guide. I already have a Pioneer-3300, but being as the dash was not made to fit a double din, there are not any install kits available. Was thinking maybe just fabricating 2 brackets to hold the unit in place (one front, on rear) Here is the dash:
Attachment 26533662Attachment 26533663
HeadUnit: sold Front Stage: 6.5 skar vxi65 + IA i65c + DB drive pro tweets Highs Amp: sold Sub Stage: all sold Sub Amp: sold Box: Wall @ ~30cu.ft. Electrical: 100ft 2/0 welding wire + 75ft 1/0 Audio Technix + 2 C&D 140's
Deadener: 100sq.ft. Audio Technix 60mil
References (sold, bought): Winkychevelle, SKARaudio x2, Patthehat033, Mazdakid, Ten_ton_bass, GAMEOVERCCA, Horsemanwill, Boomsday, Zellner, g6ryder x2, Moble Enclosurs (Box design), Goodstuff, Bread0710, dgaf, Cat Man, and many more (MAF, CACO, & ebay references available as well [110+ transactions])