thanks for that info.Quote:
I was going to do the Omega symbol but decided that since their was a large one on the box that I would do the Fj symbol on both sides. I messed up the one piece of Lexan so I might change it when I redo it.
I used this Lexan....
Amazon.com: Polycarbonate Sheet, ASTM D 3935, Clear, 1/4" Thick, 12" Width, 24" Length: Industrial & Scientific
and these LED's...
Amazon.com: Flexible Lighting Strip 300 SMD LED Ribbon 5 Meter or 16.4 Ft 12 volt BLUE, 2026BU: Home Improvement
I used my table saw to cut it to 8" x 8" squares then taped it off and drew/traced the design. Then I used a utility knife and straight edge to cut out the design, leaving the design and removing all the excess tape. I used my Dremel multi-max with the sanding attachment to frost it. It went very quickly and I used a straight edge to get up to the tape (even if you hit the tape its okay). Then remove the tape and wipe it down with alcohol. Very easy to do.