Well it's a very tight budget build. so this is what i am working with.
My AP 3002. Running 2 memphis pr 10's
Buying a bnib ap 1002 to run front channel (pg rsd 6.5's, courtesy of ls2poweredgoat.)
Fusion Powerplant Tweets.
A Ton Of Edead 45 (dont flame, it's worked **** well for me so far.)
Well Here Are Some Pix Of What I Am Working With.
My Memphis Pr 10's $185
AP 3002 hooked up to make sure it works $50
Link To AP 1002 With specs for it and the 3002
Phonix Gold RSD Mids. I had to install before i got the EDead. I blew a Memphis PR in the door. only had the tweet going. i was dying.
Here is the edead and a roller. This was my first time deadening so dont flame. If you have any suggestions go for it. tell me.
Here is the trunk lid for the most part. how does it look?
And with the trunk. everything is quiet. except for the fake light fixture on the actual trunk lid. It goes crazy everytime a note hits.
Here is what i am planning on doing for the build. I am on a tight budget, so i will be using what i can. lol
1. Pull everything out of the trunk and deaden
2. Most likely will foam within the "FAKE" light
3. Deaden Rear Deck
4. Uninstall 6.5's, Deaden, then Reinstall 6.5's
5. Construct a amp rack on each side of the trunk. 1 for the 3002, and 1 on the other side for the 1002.
Does anybody have any suggestions to make my 1/0 wire just a little bit longer to the back. I thought of a cheap alternative just tell me how well it would work. apply 1/0 ring terminals, bolt them together?
Well tell me what you think.....