Jacob's Wall Build Log

[power-fanatic07]

should be nice....seems like everyone is doing 4th orders now

[sundownz]

Framed the back wall into place on the front (also framed into place on the back as pictured before) -- starting to frame in to place the woofer baffle in :





Back chamber is 5 ft^3 before the displacement of the 2x4" lumber + any other bracing I decide to add. Figure I'll end up with around 1 cube per driver as I plan to reverse mount the subs (no sub displacement).

[ngsm13]

****.

nG

[sundownz]

Cross brace finished for the baffle... just need to build the baffle itself now :





Looks pretty strong to me

[sundownz]

Looks like I will be trying four 12s first -- not sure if I updated and made that clear in any of the posts yet.

[S.B.C.]

Someone wasted a lot of time building that. Good luck with your build.

it did 160- youve never come close to that

[Annnarbor84]

it did 160- youve never come close to that

Lawl

[sundownz]

Nothing new on the build yet -- back to work during the week so I won't have much time Want to try and get the baffle made at some point, though!

[blackxj]

looks good

[audioarsonal]

Jacob I would try and make the rear chamber a little bigger like 2 cube per woofer.You could always shrink it but I think you will get better numbers with 2 cubes then 1 cube.How large will the front chamber be?

[DB-Audio]

looks nice and strong good job so far

[sundownz]

Front chamber will be pretty huge -- 32 cubes or so.

[audioarsonal]

Have you figured out how much port area your gonna go with?That should be a low end monster if you get it dialed in right.

[power-fanatic07]

Front chamber will be pretty huge -- 32 cubes or so.

[sundownz]

I am going to start with it wide open and then measure the peak and adjust accordingly