T line build for Megalomaniac

[Linkz]

so where could I get this modeling program?

[Megalomaniac]

so where could I get this modeling program?

http://www.ptc.com/products/mathcad/

[mokedaddy]

Sorry for cluttering the thread Mir. I really would love to hear it when Im in town over winter break.

[Linkz]

http://www.ptc.com/products/mathcad/

Thanks

[Immacomputer]

So have you ever frequency tested a compression chamber and a traditional tline in a vehicle? I would be willing to bet they arent the same. Most likely close but due to differences in driver vs port placement they will vary. That was my only point. It may 'act' the same but wont be the exact same. Thus the variations of 1/4 wave enclosures.

What? I never said that a compression chamber doesn't affect the sound because I know it does. What I was saying is that the presence of the chamber doesn't make this not a transmission line. The same way that having no taper on the line doesn't stop it from being a transmission line enclosure.

[photocrazy8]

you have the nice router, pls round over the port edges next time...

[mokedaddy]

What? I never said that a compression chamber doesn't affect the sound because I know it does. What I was saying is that the presence of the chamber doesn't make this not a transmission line. The same way that having no taper on the line doesn't stop it from being a transmission line enclosure.

It all depends on your definition of a transmission line. Without question its a 1/4 wave, but definitions of the term 'transmission line' will vary depending on who you ask. I know more than a few old school designers that will not even acknowledge those as anything resembling a true tline. Which I stated. Again its just semantics and I was bored.

[Megalomaniac]

Sorry for cluttering the thread Mir. I really would love to hear it when Im in town over winter break.

meh i dont care. Good topic to discuss on.

[GAM3OVR]

what did you use with the router to cut circles?

[lilmaniac2]

jasper jig....

[ItalynStylion]

Mir, what impedance are the coils on that EU700? Want to hook it up to my O-Audio plate amp I have at my apartment? I bet we could get that thing to jazzed for sure of some real power.

[Megalomaniac]

D4 wired @ 8ohms. that would be rad to do. but you live so dam far.

Im deciding on a bunch of HT stuffs now, since i feel i am far along in my car audio portion thats done.

[James Bang]

jasper jig....

I never liked that a-hole Jasper, so I made my own jig.

[ItalynStylion]

D4 wired @ 8ohms. that would be rad to do. but you live so dam far.

Im deciding on a bunch of HT stuffs now, since i feel i am far along in my car audio portion thats done.

Dude...come on. Wired at 8 ohms that sets the plate amp at 250rms; that would be perfect. Plus, you can hear the peerless subs that I built along with the HSU setup.

[Megalomaniac]

so after 6 months of living at your new place, neighbors are cool with the bass from your ht?