View Full Version : can i fix it =( i think i messed up
05-20-2005, 11:46 PM
ok so as i am trying to make my first fiberglass enclosure..i feel as if i didnt make the mold strong enough..and with each layer i tak on..the more air bubbles and lumps arise...i was thinking of sanding down the fiberglass and then layering it right...cause after all the fiberglassing i did..i finally got the hang of it at the end. so what you guys think? can i sand it down flat and then do it righ?
05-20-2005, 11:58 PM
redo the whole thing and make it flawless :)
05-21-2005, 12:00 AM
05-21-2005, 12:11 AM
really you think i should redo the whole thing...****...ok well question..when i lay down the fiber glass...should i lay down bigger strips...or small ones? and how many layers should i put on before i let it sit and dry? i have some pix..but bad quality. ill take some tomorrow
05-21-2005, 12:14 AM
nah take it down to wheres its good, and rebuild it back up. useing a brush, poke the pices in to place, it will push the air out. dont brush them on. do small squares, like 3x3 or 4x4
05-21-2005, 12:20 AM
alright thx man..imma try it out tomorrow...see how it goes. what can i use to roll it in to place? what would be a good roller to flaten it out. thx!
05-21-2005, 12:27 AM
no need to role it on, just use a brush
05-21-2005, 01:51 AM
x2 on the poke it w/ the brush, just sand the bubbles down flat, then build it back up. i used varying sized pieces. bigger ones for the flat sections and smaller ones for the corners. also don't cut the matt...rip it, the frayed edges be stronger than the cut edges ;)