View Full Version : cutout for RE XXX 6.5"???

04-14-2005, 05:47 PM
anyone that has installed them, what is the cutout diameter for them???

04-14-2005, 05:49 PM
IIRC, I do believe it was 6.9''...

04-14-2005, 05:50 PM
thanks will see how that does.

04-14-2005, 06:39 PM
great, well it looks like its back to the design board for this guy. Can't fit those big *** bastards in my doors! I had checked it out before ordering them and thought I had enough room with a 3/4" baffle, well that is not the case I would need 1" baffle for it but then the panel would not fit on and allow for any movement.

So now to determine what to do with these suckers. They are such sweet *** drivers I don't want to get rid of them. I want to do something with them. I could put them in the rear deck but that would not work well with the imaging.

any ideas????

04-14-2005, 06:45 PM
Your lucky that you only have to make a 1" baffle... i had to make a 1.5" spacer for my doors...
and I also had to cut part of my door...

but I wouldnt suggest doing that... I had an extra set of panels that I am going to fiberglass pods for...

Ummm you could throw them in a kick panel, but it would have to be a big one... I would suggest some fiber glassing

04-14-2005, 06:57 PM
uuuugggghhh, I want to get these suckers in my car somehow and run the crap out of them. I am so anxious just to hear how powerful they are.

04-15-2005, 09:23 PM
If you're set on using the stock door location, cut through the door panel and use the 1'' spacer, you'll just have to find some 7'' grill to fit that puppy. :D Otherwise, kick it up.

04-15-2005, 09:53 PM
i couldnt fit my mids under the door panels, so i cut em and extended em. theyre not xxx's but u get the idea. u should do it too :D i actually thought about xxx's but i dont have an extra amp.

04-16-2005, 03:03 AM
You did a pretty good job on those, I like the carpeting...