PDA

View Full Version : 9815



netherland24
03-15-2005, 01:47 AM
how do i set my 9815 to where it hits on the subs hard and little less vocal? and less bass on my speakers i dont want to wear them in?

THX
03-15-2005, 02:36 AM
Hold the T-Correlation button down to get to the Crossover (high & low-pass filters). For Fronts & Rear choose a frequency you think blocks out the distortion. Don't go too high though, if your speakers can handle it it's nice to get full range sound.

For less vocals hit the EQ button twice, holding it down the 2nd time. This gives you access to the 5-band paramteric EQ. For the middle frequencies (~1Hz & ~3Hz) lower their levels a little bit. You can also boost the high and low levels here.

JoseMCeee
03-15-2005, 02:49 AM
^nice over rated stuff in your sig. 1100 watt sony sub haha

UndercoverPunk
03-15-2005, 02:52 AM
^nice over rated stuff in your sig. 1100 watt sony sub haha

Not necessary, if he was being a jerk, then I could see that comment, but all he did was ask a question...:rolleyes:

netherland24
03-17-2005, 11:34 PM
thanks man, and i just started out with this stuff i got it for free so i am going to build it all up and get better things later on when i get my new excrusion from my mom :)

jellyfish420
03-17-2005, 11:42 PM
^nice over rated stuff in your sig. 1100 watt sony sub haha
gotta start somewhere ....
i remember my first **** system;)

VoTran24
03-17-2005, 11:59 PM
how do i set my 9815 to where it hits on the subs hard and little less vocal? and less bass on my speakers i dont want to wear them in?


did you hook up your sub amp to your non fader preout from your deck?

netherland24
03-18-2005, 12:20 AM
i think soo i hooked up the RCA's from the sub amp to the head unit and hte remote wire. i am new too this and want some good sound, if u have any suggestions for a good amp for about 100$ used or new i dont really care or alittle more i would appricate it and decent subs cause sony dosent sound bad but i like something nicer cause im gready :)

VoTran24
03-18-2005, 01:02 AM
i think soo i hooked up the RCA's from the sub amp to the head unit and hte remote wire. i am new too this and want some good sound, if u have any suggestions for a good amp for about 100$ used or new i dont really care or alittle more i would appricate it and decent subs cause sony dosent sound bad but i like something nicer cause im gready :)

The 9815 has 3 pre out jacks....they are front, rear, and non fader. The first time i installed my amp a long time ago, I hooked up my sub amp to the rear preout so i didnt really get to adjust the level of the sub. But i fixed my error and changed it to the non fading pre out and it made a big difference. It allowed me to turn up my sub without raising the rest of the sound. I'm not sure if this is your problem but im just trying to help.

Have you tried adjusting the 5 band eq yet? you can do that by following the directions someone mentioned in one of the above post. try setting the eq to rock or going to the 5 band eq by holding down one of the buttons. its really hard to know what what buttons to push if you dont have the manual. If you dont have the manual try going to alpines site to see if you can get it there. goodluck man....just ask if you have any questions..be a lil more specific...