View Full Version : crossovers for home
03-05-2005, 03:39 PM
ok guys i got 4 jl audio 6w0's laying around doing nothing so i decided to build a set of tower speakers for my home theater to replace the vega's i got now. my question is where can i buy a set of cross-overs to help me accomplish this? each tower will have 2 jl's wired in series for a 8 ohm load and they will have one home theater horn tweeter as well at 8 ohm's.
03-05-2005, 04:54 PM
Parts Express should have some...
or, you could go fully active Xover'ed :)
for the 5.25" MTM's I'm building for the SE amp, I'm just using a single cap to HP the tweet, letting the woofers run full-range. For the HT setup, I'm going with an active Xover. Opposite ends, I guess.
you could always take the Rane AC22 stereo 2way Xover off my hands...wink wink, nudge nudge...
03-06-2005, 05:15 PM
03-06-2005, 05:21 PM
http://www.goldmine-elec-products.com/products.asp?dept=1080 (about halfway down the page)
Saw these the other day when I was ordering parts for my roof led project. Probably not what you are looking for, but I figured I throw it out there.
Are you looking for a xover that has some pot's on it for fine adjustment?
03-06-2005, 05:24 PM
to be honest--i'm not very knowledgable on HT so i was hoping one of the guru's on here could point me in the right direction as to what i would need to do this the right way.