Port calculation???

[Buckshot]

Alright, someone PLEASE figure out this port. I'm leaving to go get some wood, and I hope itll be here when I come back.

D=16.5"
W=30"
H=15"

I want to tune it to ~30-32 Hz. SQL kinda setup.

Driver vol = .12 Cube

Pleaseeeeeeee help meh!

[traksta15]

im sort of a newb at port calculations, but these help me out........

http://www.carstereo.com/help/Articles.cfm?id=31

http://www.eatel.net/~amptech/elecdisc/spboxnew2.htm

[ANeonRider]

www.the12volt.com
www.bcae1.com

[req]

www.r3q.net/port.html
www.r3q.net/req_files/portcalc.zip (link on the above page is down ATM - so use this one)

[bcarpenterfhl]

i'll give you the bassbox pro calculation. its usually off by 1-2 Hz., but hardly audible. i'm much too lazy right now to do it properly.

[bcarpenterfhl]

and what should your port area be?

and what the hell was wrong with your glass box?

[ANeonRider]

Go for 25in^2

[bcarpenterfhl]

with the dimensions above, i got a port length of 26.14, width of 1.75, and height of 14.5 for a tuning of 30 Hz. This brings the volume down to 2.79 ft. ^3. this was all done on bassbox pro, so it may be off by 1 or 2 Hz. (Its usually higher than it really is, so its probably somewhere around 32 Hz in reality). hope this helps.

[Buckshot]

with the dimensions above, i got a port length of 26.14, width of 1.75, and height of 14.5 for a tuning of 30 Hz. This brings the volume down to 2.79 ft. ^3. this was all done on bassbox pro, so it may be off by 1 or 2 Hz. (Its usually higher than it really is, so its probably somewhere around 32 Hz in reality). hope this helps.


Thanks buddy. :+)