View Full Version : pioneer ts-w2000spl box

06-15-2004, 02:55 PM
I was wondering if someone can design me an spl box for a competition next saturday. the sub is a 12 inch ts-w2000spl 750w rms and 2000 max. tell me what stats you need on this sub and I will post them. The max size is 15" high by 30" wide by 25" deep. I dont really car how it sounds I just want it as loud as I can get. Thanks! btw it will go in the back of my plymouth laser (same as eclipse)

06-15-2004, 11:42 PM
List all the Theil/Small parameters you have. Stuff like Qts, Qes, Qms, Vas, FS, Xmax, Re, BL, SPL.

06-16-2004, 02:00 AM
Qts- .33
Qes- .33
Qms- 15.97
Vas- 1.22 Cu Ft.
FS- 30
Xmax- .5" or 12.7 mm
Re- dual 3.0
BL- 13.46

06-16-2004, 02:43 AM
With the dimenions you gave me, I came up with just over 5 cuft of airspace.

Build the box to those specs and add 3 - 4" ports that are 9.5" long.

Let me know how that sounds.

06-16-2004, 12:49 PM
I was wondering if you can give me the dimensions for the wood?

06-16-2004, 07:18 PM
Using the deminsions you gave, cut this.............

2 peices for the Front & Back------ 30 x 15
2 peices for the Top & Bottom------30 x 23.5
2 peices for the Sides----------------23.5 x 13.5

Make sure to add braces to stiffen it.

And my disclaimer.......you supplied the deminsions to start with, if it doesn't fit in your car, not my fault. But I'm always willing to help other out. ;)

06-17-2004, 02:30 AM
Thanks I will try it and hope it fits.

06-20-2004, 01:29 PM
hey guys will that work for TS-W121SPL too ?or what , cause am lookin for a ported enclosure desgn too