PDA

View Full Version : 2014 Sundown SAE Amps on the Dyno



sundownz
06-09-2014, 02:06 PM
Had a friend of ours in the industry put these on their Amp Dyno to verify power since people have asked us about it.

All SAE amps meet or exceed ratings @ 1 % THD on the Dyno.

SAE-1000D v.2 :

http://www.sundownaudio.com/misc/protos/SAE_Amps_2014/SAE_Dyno/[email protected]

http://www.sundownaudio.com/misc/protos/SAE_Amps_2014/SAE_Dyno/[email protected]
* 1 ohm Dynamic test; works out similar to clamped results

http://www.sundownaudio.com/misc/protos/SAE_Amps_2014/SAE_Dyno/[email protected]

http://www.sundownaudio.com/misc/protos/SAE_Amps_2014/SAE_Dyno/[email protected]

SAE-600D :

http://www.sundownaudio.com/misc/protos/SAE_Amps_2014/SAE_Dyno/[email protected]
* Certified; when I did a "clamp" test on the prototype it worked out similarly to the SAE-1000D Dynamic burst as I clamped around 50% over the certified figures.

http://www.sundownaudio.com/misc/protos/SAE_Amps_2014/SAE_Dyno/[email protected]

http://www.sundownaudio.com/misc/protos/SAE_Amps_2014/SAE_Dyno/[email protected]

SAE-50.4 :

http://www.sundownaudio.com/misc/protos/SAE_Amps_2014/SAE_Dyno/[email protected]
* Per channel

http://www.sundownaudio.com/misc/protos/SAE_Amps_2014/SAE_Dyno/[email protected]
* Per channel

http://www.sundownaudio.com/misc/protos/SAE_Amps_2014/SAE_Dyno/[email protected]
* Bridged @ 4 ohms