PDA

View Full Version : Impossible Box?



idiot
06-05-2004, 08:38 PM
Would it be possible to successfully make a ported box if five out of the six sides are contoured to fit a surface that has a lot of curves. For example, in the picture below, if I were to fiberglass an enclosure that contoured to the wheel well (and there would be other curves present, but not in the picture), would I be able to port the box? Or would it just be too difficult to calculate the dimensions of the port, given the uneven surface? I know a sealed box would work, but Iím looking for a bit more output.

http://a904.g.akamai.net/7/904/506/v0011/images.autobytel.com/view/aic/TOYOTA/MATRIX/wgn/usa_2003_TOYOTA_MATRIX_wgn_4_x_incargo_x.jpg

Moe Lester
06-05-2004, 09:45 PM
You can definately port it, to calculate the volume, fill it up with packing peanuts or water or something and measure the amount thats in there. Sounds like a sweet project :)