PDA

View Full Version : flush mount???



Lowridin_Chevy
05-28-2004, 11:27 PM
any1 know the steps for doing a recessed mount for a subwoofer where the sub is flush with the wood

smullen
05-28-2004, 11:42 PM
Depending on the thickness of the driver... You could do it a few ways, buth using a router or something simmilar...


1. On your baffle where the sub goes, use a router to cut a hole, then Rabbit a second hole around the 1st for the driver lip to sit in thus making it flush... However, you are making the baffle a lot thinner by doing it this way..


2. Cut a hole in the baffle like normal, mount the sub, then add a second baffle peice on top of that with a hole cut out for the woofer itself to fit though, making it look flush...

Hops those makes sense...

pj2003
05-29-2004, 06:39 PM
the idea i had was make a regular hole the siz of the OUTSIDE of the sub ring not the screws. then take another piece of wood and liquid nail it to the inside of the box but the piece of wood on the inside of the box would be the sub baffle.......could that work or would it be unsturdy if thats a word

helotaxi
05-29-2004, 06:43 PM
Make sure that it is plenty wide to give sufficient overlap between the two pieces of wood. I would use screws in addition to liquid nails and make sure that there are no leaks.