View Full Version : Need Help With Box Design

02-03-2014, 05:13 PM
I need help with my box design, I can send a couple bucks on PayPal to whoever will design it for me. I have a 1995 Jeep Grand Cherokee and I want a box for a Stereo Integrity HT 18 2OHM DVC 600 rms sub.

600 RMS

18" D2
Re: 3.5 Ohms
Fs: 17 Hz
Qes: 0.41
Qms: 5.8
Qts: 0.38
Le: 3.2 mH
Sd: 117841 mm^2
Vas: 411.9 l
BL: 19.7
Mms: 416 g
Cms: 208.8
Sensitivity (1W/1m): 88.7 dB
Xmax: 22.5mm

Recommended enclosures: 18"
Sealed = 4 ft^3
Ported = 5-6 ft^3 tuned to 20 Hz
Cutout: 16.7"
OD: 18.5"
Mounting depth: 9.5"
Mounting flange to top of surround: 1.5"
Displacement: 0.25 ft^3

Seen at this thread http://www.caraudio.com/forums/subwoofer-classifieds/598960-stereo-integrity-18s-%24165-shipped-each.html

The box should be 32" length ( <---> this way) 26" deep, and around 22" tall. A ported enclosure, and I am not really sure about how I want it tuned. It recommends 20Hz but I'm going for a mix of SPL and SQ more oriented towards the SPL side. If anyone will design it for me like I said I will throw them a couple bucks. Slot port too, by the way. I want something fairly easy to build.

Thank you!!

02-03-2014, 05:41 PM
I can design it for you. You can email me, [email protected] or pm me.

02-03-2014, 09:31 PM
PMd you thank you