PDA

View Full Version : worth the upgrade?



bradl79
11-20-2013, 04:58 PM
I have pair of midbass Exodus Anarchy 8 ohm (bridged at 4 Ohm in series) or upgrade to pair of CDT M6+ 4 ohm. Would it be worth it or should I stay with what I have. Freq range will be 80Hz - 600Hz and installed in doors and doors are deadened with 80mil

neo_styles
11-20-2013, 05:08 PM
Keep the anarchy

trumpet
11-20-2013, 05:22 PM
M6+ is designed for small sealed or ported enclosures, which your door is neither. I would do more work to treat the doors. "80 mil" deadener is only addressing one of several obstacles to getting good bass from a door.

bradl79
11-20-2013, 05:33 PM
Ok I have deadened front & back of the panels and the inside if that is any help and I also have baffles on the speakers too. So I assume the M6s will be the same as the M6+. Better for a sealed enclosure.

bradl79
11-20-2013, 11:32 PM
Since i am still learning to get the best quality out of speakers. With the anarchy i have them in the rear doors should ido anything else with them?.

trumpet
11-21-2013, 10:17 AM
Ok I have deadened front & back of the panels and the inside if that is any help and I also have baffles on the speakers too. So I assume the M6s will be the same as the M6+. Better for a sealed enclosure.

No, M6 is suitable for use in a door like most other car speakers. You can put M6 in a small sealed or ported enclosure, but it's not as important as with M6+. That little + sign means more than the differences between HD-6 and HD-M6 as far as suitable enclosures. Think of HD-M6 like a midbass woofer, and M6+ as a small box subwoofer.

mlstrass
11-22-2013, 03:54 AM
I would keep the anarchy mids. Perhaps they need more power, doors need more treatment and also play them down lower as they will dig deeper then 80Hz...

bradl79
11-22-2013, 02:04 PM
how low should i go with them? i don't know what else i could do with my doors though, i have deadener all over my doors and inside the panels too.

Front Left, back is the same
https://lh4.googleusercontent.com/-nlbmjt5ARSE/UknULvW5ZjI/AAAAAAAAFxQ/k9KygqfRut4/w1216-h684-no/20130927_150947.jpg

trumpet
11-22-2013, 04:56 PM
Brad, deadener alone is just one thing you can do to treat doors. CCF and MLV plus absorption inside the door is what you can work on next.