PDA

View Full Version : Alpine Type R 10"



aguynamedfre
09-28-2013, 10:22 PM
Hey everyone I'm going to get a alpine type r 10" dual 2 ohm voice coil. I am going to wire it to 2 ohms and then I need an amp. Alpine says 600 watts rms and I have read you can run 150% of that rms which would be 900 amps. So my question is what amp should I get to power this and I'm going to put it in a ported box. Also what are everyone's opinions on fierce audio 10" ported boxes.




Item(s) Description/Condition:




Price:




Shipping and Miscellaneous Item Information:




Item Pictures:
(List pictures in this section, 1st picture should be your username/date if you have less than 10 positive feedbacks with the i-Trader system or less than 10 references that you have sold to in the past. (These must be listed in your signature, or a link provided to a feedback thread listing these references)).

Slo_Ride
09-28-2013, 10:23 PM
wrong section

CaptainMaximus
09-28-2013, 10:51 PM
Better make it a clean signal or it'll cook that sub dude

audiobaun
09-29-2013, 04:28 AM
Best get a DVC 4 ohm if you plan on running @2 ohms for a single sub,and keep it @rms ratings for it to last.

RoYALbLUE08
09-29-2013, 08:37 AM
buy my 2012 alpine type r subs rated for 1000 watts RMS each! im trying to sell my **** subs to get an SSA XCON!