PDA

View Full Version : SOLD/CLOSED FS: Sundown Sax-100.4



basshead7890
08-29-2013, 08:50 AM
1. Product:
Sundown SAX-100.4


2. Specs:

4/3/2 Channel Bridgeable Class-AB Amplifier
MOSFET PWM Power Supply
Stable Into 4 Ohms Bridged or 2 Ohms Stereo Load
Variable Subsonic Filter
Independent 1/2 and 3/4 Channel High Pass Filter Variable
with x 10 Range Selectable Switch
Independent 1/2 and 3/4 Channel Low Pass Filter Variable with x 10 Range Selectable Switch
HPF/FULL/LPF Selectable Switch
Independent 1/2 and 3/4 Channel Electronic Crossover Slope Selectable
Switch with 12dB and 24dB Octave
Variable Input Level Control
Input Sensitivity : 200mV ~ 6V
Subsonic Filter : 10Hz ~ 500Hz
Signal Input and Line Out RCA Connectors
Multi-Way Protection circuitry (Thermal/Over Current/Speaker Short/Speaker DC protection)
Tested Voltage & THD: 14.4V & Less than 0.05% THD
Operating Voltage : DC10V~16V Power Input

Rated power output

----RMS power, 4 ohm stereo 100W x 4CH

----RMS power, 2 ohm stereo 160W x 4CH

----RMS power, 4 ohm bridged 320W x 2CH
Signal to Noise Ratio >90dB
Low pass frequency crossover


50Hz~500Hz (CH1&2)
50Hz~5KHz (CH3&4)

High Pass Crossover


50Hz~5KHz (CH1&2)
50Hz~500Hz (CH3&4)
Variable Subsonic Filter 10Hz to 500Hz
Frequency Response 10Hz ~ 40KHz (+/-1dB)
Bass Boost 0~18dB
Variable Bass-Boost Frequency Control 35Hz to 120Hz
Frequency Response 10Hz ~ 40KHz (+/-1dB)
THD@RMS Watts <0.1%
Channel Separation 75dB
Fuse Rating 30A x 3
Input Sensitivity Variable 200mV~6V (+/- 5%)
Dimensions 252(W) x 58(H) x 480(L)mm

3. Description/Condition:
10/10mechanical
7.5/10 cosmetic
A little dusty and a couple of small nicks & scratches.


4. Price: :

$250 shipped
No Trades


5. Pictures:
http://imageshack.us/a/img832/4421/4y6q.jpg
http://imageshack.us/a/img827/5162/gc5t.jpg
http://imageshack.us/a/img690/1430/i1ef.jpg
http://imageshack.us/a/img547/936/2eup.jpg















** DO NOT DELETE ANYTHING BELOW THIS LINE OR THREAD WILL BE DELETED **
-----------------------------------------------

This message is automatically inserted in all classified threads.

Please be advised, all buyers and sellers should satisfy themselves that the other party is genuine by providing the following via PM to each other after negotiations are complete and prior to dispatching goods and making payment:

1) Telephone number. Call the number back at a unspecified time and make sure that it is the person's correct phone number.

2) Name and address including postal code

3) Valid e-mail address. Send an e-mail requesting a response to information about the deal being made.


DO NOT proceed with a deal until you are completely satisfied with all details being correct. It's in your best interest to check out these details yourself.

If transaction was completed on CACO, please use iTrader to record feedback.

Potential buyers/seller should check iTrader feedback also before continuing transaction.

BoomBoxStereo
08-29-2013, 09:07 AM
It does 160x4 at 4 ohm?

---------- Post added at 09:07 AM ---------- Previous post was at 09:07 AM ----------

Wait didn't see it said bridged I was like "whaaaaat"