PDA

View Full Version : CT Sounds 500.1, 750.1, 900.1, and 1400.1 clamp test



cthedinger
08-20-2013, 02:24 PM
http://www.youtube.com/watch?v=tz68WzCN_ZY

CT Sounds CT 500.1d Clamp Testing
Clamped 702.6w at .81 ohms
Test was done on at 15.2v and dropping to 14.9v
148.3 db on TermLab




http://www.youtube.com/watch?v=uT9fNto6T1I

CT Sounds 750.1d Clamp Testing
Clamped 840.5w @ .84 ohms
Test was done on at 15.2v and dropping to 14.9v
149 db on TermLab




http://www.youtube.com/watch?v=vMdan6l7vuo

CT Sounds 900.1d Clamp Testing
Clamped 1083w @ .81 ohms
Test was done on at 15.2v and dropping to 14.9v
150.3 db on TermLab




http://www.youtube.com/watch?v=N6AA1etcDbk

CT Sounds 1400.1d Clamp Testing
Clamped 1878w @ .82 ohms
Test was done on at 15.2v and dropping to 14.9v
152.6 db on TermLab

SMS
08-20-2013, 02:43 PM
are they stable under 1 ohm on the warranty?

naughtyca
08-20-2013, 03:04 PM
15.2V, can you do testing on real scenario like 13.8V, I have not seen any car, suv or truck that runs 500w,750w,900w or even 1400w sub amp that has 15.2v. most of the time 15.2V vehicles runs over 2k-3k watts.

can you correct me if i am misunderstanding this

casey_anthony
11-07-2013, 07:20 PM
i too would like to know how these amps perform at half ohm and quarter ohm loads. this is of course assuming steady 15v power supply