PDA

View Full Version : Zed Audio Leviathan III 6 channel amplifier Mint condition Priced to sell



Vertex Audio
06-26-2013, 08:27 PM
Item(s) for Sale:
Zed Leviathan III



Item(s) Description/Condition:
Mint condition, used very little. Still has film on plexi glass. Has been tested and is guaranteed to work upon arrival!

Specs:
Continuous Output Power into 2 ohm: 330w x 6
Continuous Output Power into 4 ohm: 190w x 6
Continuous Output Power into 6 ohm: 125w x 6
Continuous Output Power into 8 ohm: 100w x 6
Continuous Output Power 3 pairs of channels bridged into 4 ohm: 660w x 3 Channel pairs may be bridged independently
Continuous Output Power 2 channels bridged into 8 ohm: 380w x 3 Channel pairs may be bridged independently
Minimum Speaker Impedance: 2 ohm per channel
Minimum Speaker Impedance in Bridge Mode (2 channels): 4 ohm
Frequency Response at rated power into 4 ohms: 10Hz-30KHz -0.1dB
Input Voltage range for rated power into 4 ohms: 0.25 to 8.6 volt
Input Impedance at 2KHz: 47K ohm
Noise below rated output (30KHz limited) -100dB
Channel separation at 2KHz: >80dB
Damping Factor at 20Hz with 4 ohms: >80
Total Harmonic Distortion with 4 ohm: 0.05%
High Pass Crossovers (24dB/octave) Channels 1+2 and 3+4: 55Hz-4KHz
Low Pass Crossovers (24dB/octave) Channels 3+4: 55Hz to 4KHz
High Pass Crossovers (24dB/octave) Channels 5+6: 10Hz-105Hz May be used as a Sub Sonic Filter
Low Pass Crossovers (24dB/octave) Channels 5+6: 40Hz to 235Hz
Protection: Short Circuit, DC, Thermal
Power Source: 10-14.5v DC Negative Ground
Current Consumption with Sinewave at 4 ohms: 94A
Current Consumption with Music at 4 ohms: 18 to 28A
Idling Current: <1.5A
Fuse rating with 4 ohm load: 30A-40A depending on usage
Fuse rating with 2 ohm load: 40A -80A depending on usage
Size W x H (247mmx55mm/9.7x2.1) x L: 410mm/16.14 Excludes connectors
Made in USA



Price:

$650 shipped. It is currently up on ebay. If a bid is received then this thread will be closed as SOLD.




Shipping and Miscellaneous Item Information:
FREE



Item Pictures:
(List pictures in this section, 1st picture should be your username/date if you have less than 10 positive feedbacks with the i-Trader system or less than 10 references that you have sold to in the past. (These must be listed in your signature, or a link provided to a feedback thread listing these references)).

BigSix
06-26-2013, 09:07 PM
The things I would do for this amp .....luckily Im starting shutdown at my job so I work 14 hr shifts the next 3 weeks so I will be buying one in the next couple....GLWS and awesome price!

Vertex Audio
06-26-2013, 11:18 PM
The things I would do for this amp .....luckily Im starting shutdown at my job so I work 14 hr shifts the next 3 weeks so I will be buying one in the next couple....GLWS and awesome price!


We will be having a special this upcoming month on them while supplies last, so keep an eye out!

NoLoud4U
06-26-2013, 11:32 PM
This amps has a wicked CO section. If I set my mid bass HPF at the HU can this amp run full 3 way active? And can it run all 6 channels off 4 RCA ins?

clickclickw00t
06-26-2013, 11:38 PM
This amps has a wicked CO section. If I set my mid bass HPF at the HU can this amp run full 3 way active? And can it run all 6 channels off 4 RCA ins?

just get a splitter. This is the EXACT amp I want I just can't afford that price right now. GLWS!

BigSix
06-26-2013, 11:46 PM
Item(s) for Sale:
Zed Leviathan III



Item(s) Description/Condition:
Mint condition, used very little. Still has film on plexi glass. Has been tested and is guaranteed to work upon arrival!

Specs:
Continuous Output Power into 2 ohm: 330w x 6
Continuous Output Power into 4 ohm: 190w x 6
Continuous Output Power into 6 ohm: 125w x 6
Continuous Output Power into 8 ohm: 100w x 6
Continuous Output Power 3 pairs of channels bridged into 4 ohm: 660w x 3 Channel pairs may be bridged independently
Continuous Output Power 2 channels bridged into 8 ohm: 380w x 3 Channel pairs may be bridged independently
Minimum Speaker Impedance: 2 ohm per channel
Minimum Speaker Impedance in Bridge Mode (2 channels): 4 ohm
Frequency Response at rated power into 4 ohms: 10Hz-30KHz -0.1dB
Input Voltage range for rated power into 4 ohms: 0.25 to 8.6 volt
Input Impedance at 2KHz: 47K ohm
Noise below rated output (30KHz limited) -100dB
Channel separation at 2KHz: >80dB
Damping Factor at 20Hz with 4 ohms: >80
Total Harmonic Distortion with 4 ohm: 0.05%
High Pass Crossovers (24dB/octave) Channels 1+2 and 3+4: 55Hz-4KHz
Low Pass Crossovers (24dB/octave) Channels 3+4: 55Hz to 4KHz
High Pass Crossovers (24dB/octave) Channels 5+6: 10Hz-105Hz May be used as a Sub Sonic Filter
Low Pass Crossovers (24dB/octave) Channels 5+6: 40Hz to 235Hz
Protection: Short Circuit, DC, Thermal
Power Source: 10-14.5v DC Negative Ground
Current Consumption with Sinewave at 4 ohms: 94A
Current Consumption with Music at 4 ohms: 18 to 28A
Idling Current: <1.5A
Fuse rating with 4 ohm load: 30A-40A depending on usage
Fuse rating with 2 ohm load: 40A -80A depending on usage
Size W x H (247mmx55mm/9.7”x2.1”) x L: 410mm/16.14” Excludes connectors
Made in USA



Price:

$650 shipped. It is currently up on ebay. If a bid is received then this thread will be closed as SOLD.




Shipping and Miscellaneous Item Information:
FREE



Item Pictures:
(List pictures in this section, 1st picture should be your username/date if you have less than 10 positive feedbacks with the i-Trader system or less than 10 references that you have sold to in the past. (These must be listed in your signature, or a link provided to a feedback thread listing these references)).

do tell sir, pm me if you can about this deal that is coming up

hispls
06-27-2013, 08:43 AM
This amps has a wicked CO section. If I set my mid bass HPF at the HU can this amp run full 3 way active? And can it run all 6 channels off 4 RCA ins?

The amp can do all crossover points without using head unit. It has subsonic (which goes up to @ 42) for midbass, then you can go wherever you like on the other channels. I can't imagine how you would need any other crossover.


We will be having a special this upcoming month on them while supplies last, so keep an eye out!

Any chance you can use anything in trade on this one?

Jroo
06-27-2013, 09:08 AM
I just want to be clear about the xovers. I run and old school deck head eclipse that doesnt have any xovers in it. With this amp, I can do three way active (tweets, mids, midbass)? I just want to make sure becasue I was told this amp has great high pass and low pass, but not bandpass.

jockhater2
06-27-2013, 03:03 PM
Someone buy my Audison LRx 6.9k so I can buy this zed amp

jockhater2
06-27-2013, 08:48 PM
mark this amp as sold.
send me an invoice to my paypal. jockhater2@hotmail.com
Or I can buy it on ebay. Since it's the same price.
Any discount for no ebay fee's?

Vertex Audio
06-27-2013, 10:26 PM
mark this amp as sold.
send me an invoice to my paypal. jockhater2@hotmail.com
Or I can buy it on ebay. Since it's the same price.
Any discount for no ebay fee's?

Invoice/pm sent

Vertex Audio
06-27-2013, 10:43 PM
This amps has a wicked CO section. If I set my mid bass HPF at the HU can this amp run full 3 way active? And can it run all 6 channels off 4 RCA ins?
Why do you want to run your hpf at the HU? Why not set it at the amp? Also I believe you can run all 6 channels with 4 rca ins, just use splitters.


I just want to be clear about the xovers. I run and old school deck head eclipse that doesnt have any xovers in it. With this amp, I can do three way active (tweets, mids, midbass)? I just want to make sure becasue I was told this amp has great high pass and low pass, but not bandpass.

Yes, this amp has a band pass! In the pictures you can see the options. Looks like the tweeter would be at 4k hz or lower.

Hope this helps!

NoLoud4U
06-27-2013, 10:55 PM
Why do you want to run your hpf at the HU? Why not set it at the amp? Also I believe you can run all 6 channels with 4 rca ins, just use splitters.



Yes, this amp has a band pass! In the pictures you can see the options. Looks like the tweeter would be at 4k hz or lower.

Hope this helps!

That's how I run it now. Mid bass is cut off at 60 from the HU. That's the only way I can do it now. HU cuts off the bottom end of the mid bass, amps cover the rest.

Vertex Audio
06-28-2013, 02:59 PM
Sold!