PDA

View Full Version : how do i convert circular port to slot vented help me i have to start tomorrow!!!!



Nutdawg651
06-17-2013, 03:01 AM
so i get all my dimensions research everything i need to build my new box tomorrow go buy all the materials and tonight i open the speaker package to go over all parameters one more time , and i read the speaker is optimal in a box with a circular port witch i do not want to find or spend anymore money im way over budget from borrowing i want a new type r , ne ways i have my design and its a slot port does anyone know how to convert the dimensions from circular to slot while still getting 36 hz or am i good with wat i have now ???

26543165

Nutdawg651
06-17-2013, 04:20 AM
@double 07 , @pro-rabbit

black05alti
06-17-2013, 05:36 AM
double 07[/MENTION] , pro-rabbit
double 07 ; pro-rabbit ;

pro-rabbit
06-17-2013, 09:39 AM
What sub?

Nutdawg651
06-19-2013, 12:32 AM
What sub?

Powerbass xxxl 12 1ohm dvc

tommydh
06-19-2013, 01:33 AM
I think that is tunned a little higher than 36Hz try the port at 2"

Nutdawg651
06-19-2013, 11:13 AM
I think that is tunned a little higher than 36Hz try the port at 2"

Yea I got the plans from someone on this forum not gonna say no names I knew they were shady because some of the cut pieces dont fit together I have to use a filler and seal it good I gues I could just take a small cut piece a glue it to the edge at the port and make it 2 inches

black05alti
06-19-2013, 11:18 AM
Should've gotten Buck ; to design your box ;)

Nutdawg651
06-19-2013, 11:31 AM
Yea I know now for the next one I think he was tryna **** my **** up I wasted alot of money but ill improvise

southernboom88
06-19-2013, 12:17 PM
precision port has a calculator on their website, just enter box dimensions and play with port diameter and length till you get what you need. hope that helps. btw- the 3" diameter port kit cost about $16 or so shipped. more $ for a larger diameter.

tommydh
06-21-2013, 01:37 PM
Yea I got the plans from someone on this forum not gonna say no names I knew they were shady because some of the cut pieces dont fit together I have to use a filler and seal it good I gues I could just take a small cut piece a glue it to the edge at the port and make it 2 inches
you could just double up on te port wall to th inside of it it would make your port openig smaller. did you get plans from them or a kit if just plans te cuts are on you , but kit its on them.