PDA

View Full Version : 2 DD 2515's Enclosure



JayDubb757
06-08-2013, 10:59 PM
I'm building an enclosure for a customer for 2 Digital Designs 2515's.
It's going in a 2006 Dodge Magnum.
Powered by 2 Logic TX3000D's strapped at 2ohms.
6 cubes tuned to 37hz






http://i40.tinypic.com/24g6j5h.jpg

http://i39.tinypic.com/9hhvue.jpg

http://i40.tinypic.com/2vd3dqu.jpg

JayDubb757
06-08-2013, 11:01 PM
http://i40.tinypic.com/2uiis7a.jpg

http://i44.tinypic.com/30vgfae.jpg

http://i40.tinypic.com/2qbyuir.jpg

http://i40.tinypic.com/2ro12ro.jpg

JayDubb757
06-08-2013, 11:05 PM
http://i44.tinypic.com/1o2m1j.jpg

http://i43.tinypic.com/f2r39t.jpg

http://i39.tinypic.com/nv7894.jpg

http://i41.tinypic.com/abnmup.jpg

JayDubb757
06-08-2013, 11:08 PM
http://i44.tinypic.com/2v2cazc.jpg

http://i41.tinypic.com/bfur8.jpg

http://i40.tinypic.com/2w2ndd5.jpg

JayDubb757
06-08-2013, 11:11 PM
http://i40.tinypic.com/5zgl5t.jpg

http://i40.tinypic.com/9sa49x.jpg

http://i43.tinypic.com/imtdoi.jpg

http://i44.tinypic.com/2efj4h5.jpg

Radiospank
06-09-2013, 03:37 AM
Nice work that port looks hard to build, do u use a table saw sled for the big cuts?

JayDubb757
06-09-2013, 10:32 AM
Nice work that port looks hard to build, do u use a table saw sled for the big cuts?

Thanks!
Nope, just a table saw, no sled.

Radiospank
06-10-2013, 03:39 AM
oh was just wondering because my table saw only does 24.5 width and some of my cuts are over that, i need to make a sled for these bigger cuts.

JayDubb757
06-10-2013, 08:06 AM
oh was just wondering because my table saw only does 24.5 width and some of my cuts are over that, i need to make a sled for these bigger cuts.


I work at a cabinet shop, the table saws will handle 12ft long ply.
Build a table the same height as the saw, to help handle it better.