PDA

View Full Version : Skar Audio LP-1000.1D Clamp Test Video



SkarAudio
05-23-2013, 12:17 PM
Today we put the brand new Skar Audio LP-1000.1D to the test with a quick Clamp Test. This test was done @ a 2 Ohm Load since it was shot last minute, but nonetheless you can see the power output these little monsters are capable of :-)

Very high quality amplifiers at a reasonable price!

Model : LP-1000.1D (http://skaraudio.com/amplifiers/lp_series/LP-1000.1D)

These amplifiers are 1 Ohm Stable and MAP is $299.99

We will make more video's of this in action shortly, so stay tuned!

Enjoy!


http://www.youtube.com/watch?v=1uk_1f7SZpw

gckless
05-23-2013, 12:28 PM
So did you test that tone itself at all? Do you trust a youtube video, coming from your computer, to not be distorted in any way?

raptor727
05-23-2013, 12:34 PM
So let me get this straight it was wired at 2ohms with little to no rise and barely gets half of it's rms??? Have to ask because it claims 700rms @2ohms None the less if it does do rated looks like a good buy and sleek design, although i would like to see a real clamp test with good equipment and an actual system..

BoomBoxStereo
05-23-2013, 12:40 PM
400 watts at two ohms shouldn't get that sub hot at all considering it's rated at 600 rms

also 450 x 2 does not equal 1000 lol

J31Rob
05-23-2013, 12:42 PM
"Still the quality you expect from Skar Audio."

http://i.imgur.com/lbyu9lB.jpg

MecaVA
05-23-2013, 12:51 PM
sounds a little clipped

2000LaDe
05-23-2013, 12:52 PM
400 x 2 = practically 1000 watts

2000LaDe
05-23-2013, 12:56 PM
well its a good thing you rated the amp at 700 watts at 2 ohm. its a shame you cant design or rate your own products accordingly

J31Rob
05-23-2013, 12:56 PM
Pretty much..

2000LaDe
05-23-2013, 01:04 PM
excuse me while i smash my head into the table from this whole thing.

SkarAudio
05-23-2013, 01:05 PM
well its a good thing you rated the amp at 700 watts at 2 ohm. its a shame you cant design or rate your own products accordingly

I guess I should have explained further that we were using a signal that we typically do not - YouTube, just for a quick video. My normal source unit with Test Tones (High Quality) I did not have and my iPhone was being used to film the video. The Amplifier even on a bad signal with distortion had a lot more punch to offer and was not turned up nearly to where it could have been. I will follow this video up with a 1 Ohm video on a clean signal to show the potential.