View Full Version : need help with sub box design

02-25-2013, 09:24 PM
im designing a box and here what i got so far

depth-20in (my only mesurment that can be changed)
thicknes-.75 (mdf)
bracinng vol-204in^3
port vol-173.91 in^3
driver vol- .08 ft^3 x 4 (using 4 subs)
total vol- 2.874 ft^3 or 81.378 liters

slot port
qty of ports- 1
enclosure vol-2.874ft^3
port hight- 8.5in
port width-2in
vent length-10.23 in

tuned at 32 hz

does this all add up right? im doing the port on the end but its not an L port it just goes straight back and the 10.23 in and stops is that ok or if its on the end does it have to be an L port? its for 4 sundown audio sa-8 v2's i just need to make sure my design will work

02-25-2013, 09:29 PM
My laptop is crapped out or I would run the #'s for ya.

Kick arse setup... What kinda power u going with?

02-25-2013, 09:41 PM
i was thinking 2 saz-1500d's if i have the money i usesd the calculators i found online to get all the numbers i just 1. dont know if there 100% right and 2. want a prefesionals opinion