PDA

View Full Version : setting up multiple speakers??



seankurz
02-13-2013, 07:06 PM
My head unit's manual only had diagrams for normal mode, 2 way mode, and 3 way mode, which I am attaching photos of. My question is how specifically do I run it the way I have it shown in the other picture?? With the complexity of systems today, I'm sure this is doable but I haven't found anything on how to so far, its been almost a day and a half of searching... :mad::mad:

I will be running a clarion cz702 head unit, an image dynamics CXT component set on an alpine MRX-F65, a matching CTX coaxial set off of an alpine MRP-F300, and a RF 210 sub off of a power acoustic amp (going to upgrade to RE sub/amp in trunk)

How would I run this all out of the HU, specifically? do I need external hardware, or...?

seankurz
02-14-2013, 01:02 AM
i want to use the TA on the HU for the comps, but also keep the coax speakers and sub..
would the setup i mentioned be okay or is there a better way to achieve what i want to do?
HU rear rca outs>>>alpine MRX-F65>>>tweeters
HU front rca outs>>>alpine MRX-F65>>>mids
HU sub rca outs>>>fullrange signal>>>alpine MRP-F200>>>F300 rca outs>>>sub amp xover to filter out all but the lows.

calebkhill
02-14-2013, 04:16 AM
What kind of car. I used to have my hu front outs to tweets and hu rear outs to front and rear speakers.

seankurz
02-14-2013, 04:27 AM
I used to have my hu front outs to tweets and hu rear outs to front and rear speakers.

its an 05 saturn ion coupe.
how did you hook up the 4 ch amp for those to the HU? just the rear rca outs?

calebkhill
02-14-2013, 06:48 AM
Yes, use Y cables.