PDA

View Full Version : SOLD/CLOSED MMats M2000.1 Power house!!



crxjim29
02-03-2013, 03:21 PM
Item(s) for Sale:

MMats m2000.1


Item(s) Description/Condition:

up for sale is a mmats m2000.1d works great has some blemishes as pictured,i ve only sold one item on this web sight and still new to selling up here,but i have sold right much on ebay,and i have this on ebay right now jbw0077 259 posifeedback,id rather sell it up here cause ebay gets 9% of final sale,there is absolutely nothing wrong with this amp,other than the cosmetics,and its not that bad,im just peculiar.too be as small as this amp is it is a true power house!i will ship same day as payment sent,if possible,you will not be dissatisfied,paypal is perfered payment that way we are both protected,here are some specs:2000rms@1ohm and 1100@2ohms
M2000.05D/M2000.1D/M2000.2D

M2000.1D
STABLE TO: 1ohm


CONTINUOUS (RMS) POWER
@ 13.8 Volts 2000rms@ 1ohm and 1100@2ohms


Signal to Noise Ratio A-Wtd: <85dB <85dB <85dB
Total Harmonic Distortion: 0.3% 0.3% 0.3%
Channel Separation: N/A N/A N/A
Input Sensitivity: 150mV-2.5V 150mV-2.5V 150mV-2.5V
Slew Rate: 13V / Usec 13V / Usec 13V / Usec
Fuse Rating: 100 amp 100 amp 100 amp
Dimensions:

Height: 2.25” 2.25” 2.25”
Width: 9.5” 9.5” 9.5”
Length: 10” 10” 10”

General Information:

Frequency Response: <10Hz to 275Hz
Low-pass Filter: Variable 24db, 77 to 275Hz
Battery Connectors: 2 Gauge
Speaker Connectors: 8 Gauge


CONTROLS AND CONNECTORS

(1) Positive Power Terminals –This is the power feed from the positive (+) terminal of the car’s battery. Use 4-gauge cable (MINIMUM) and good quality terminals when routing this connection. Tighten all connections well to prevent power loss due to bad contact. Route the power cable away from the RCA jacks and speaker cables

(1) Ground Terminals - For optimum performance, use 4-gauge cable MINIMUM! Connect this cable to your battery’s negative (-) terminal or to a secure area of the body in the trunk. *See note below.

Remote Terminal - The amplifier will turn on when 12 volts is applied to this terminal. This 12-volt signal is usually taken from the Power Antenna or Remote wire coming from the source unit.

Speaker Terminals - Connect to speakers using 16-gauge wire (minimum). Running too low of a speaker impedance will cause the amplifier to go into a fault condition.

Crossover Filter – Linkwitz/Riley 24db slope. This control sets the 6db down point of your amplifier.

Gain – Allows input levels between 150mV (max gain) and 2.5 volts (min gain) for full output.

Recommended Fuse – 80 amperes.

Recommended Battery: You should use 1 battery for each pair of amplifiers. If your system uses only 1 amplifier, then the starter battery is sufficient. Note: When you have to parallel 2 or more batteries together always use the same, size, brand and amperage of battery. This will ensure that the batteries charge equally. We do not recommend battery isolators. At 2 or more batteries, you will need to upgrade your alternator. The starter battery should always be upgraded with a high output audio battery.

Note: If you use the chassis as a source for your ground in the trunk, you MUST increase the size of the wire that runs from the front battery to the fender. Remember; 12 volts has to run in a continuous loop and if you do not increase the ground wire up front the voltage/current will be restricted and your system will not play to its fullest.


Price:

350.00


Shipping and Miscellaneous Item Information:

free


Item Pictures:
[I]http://i1048.photobucket.com/albums/s373/crxjim29/20130203_145806_zps8da01fb5.jpghttp://i1048.photobucket.com/albums/s373/crxjim29/20130201_125000_zps917f7258.jpghttp://i1048.photobucket.com/albums/s373/crxjim29/20130203_145748_zpse17301bd.jpg

ThatChevyGuy
02-03-2013, 03:22 PM
use img not ahref

mylows10
02-03-2013, 03:24 PM
your pics dont work

TheUnderFighter
02-03-2013, 03:27 PM
You should clarify, or clean that copy/paste up, that you are selling the 1-ohm version of this Amplifier, and not the 1/2 or 2-ohm version. This one is not stable down to .5, and makes it's most power at 1-ohm. These are phenomenal amps here guys. You do need pictures of the amp, with your username and date though.

crxjim29
02-03-2013, 03:27 PM
k thanx,let met see,new to this

crxjim29
02-03-2013, 03:36 PM
You should clarify, or clean that copy/paste up, that you are selling the 1-ohm version of this Amplifier, and not the 1/2 or 2-ohm version. This one is not stable down to .5, and makes it's most power at 1-ohm. These are phenomenal amps here guys. You do need pictures of the amp, with your username and date though.
Thanx,Thats Right this will do 2000rms@1ohm and 1100@2ohms at 13.8v

momax_powers
02-03-2013, 05:42 PM
The recommended fuse is 80 amperes or 100amp according to the description

So is that 2000@1ohm a Max or rms rating

13.8v x 100a = 1380watts before the fuse blows

Or am I missing something?

Does anyone know if this does rated as I wouldn't mind picking it up

kushy_dreams
02-03-2013, 05:45 PM
The recommended fuse is 80 amperes or 100amp according to the description

So is that 2000@1ohm a Max or rms rating

13.8v x 100a = 1380watts before the fuse blows

Or am I missing something?

Does anyone know if this does rated as I wouldn't mind picking it up


The fuse won't blow immediately when gets more current than its rated for. You have to run 3-4x the amount of rated current through a fuse for it to blow instantly, so most likely the amp will pull slightly more than 100a for short periods of time when driven hard. These amps are stupid efficient so they don't draw a lot of current.

GreekBrotha8
02-03-2013, 05:51 PM
Item(s) for Sale:

MMats m2000.1


Item(s) Description/Condition:

up for sale is a mmats m2000.1d works great has some blemishes as pictured,i ve only sold one item on this web sight and still new to selling up here,but i have sold right much on ebay,and i have this on ebay right now jbw0077 259 posifeedback,id rather sell it up here cause ebay gets 9% of final sale,there is absolutely nothing wrong with this amp,other than the cosmetics,and its not that bad,im just peculiar.too be as small as this amp is it is a true power house!i will ship same day as payment sent,if possible,you will not be dissatisfied,paypal is perfered payment that way we are both protected,here are some specs:2000rms@1ohm and 1100@2ohms
M2000.05D/M2000.1D/M2000.2D

M2000.1D
STABLE TO: 1ohm


CONTINUOUS (RMS) POWER
@ 13.8 Volts 2000rms@ 1ohm and 1100@2ohms


Signal to Noise Ratio A-Wtd: <85dB <85dB <85dB
Total Harmonic Distortion: 0.3% 0.3% 0.3%
Channel Separation: N/A N/A N/A
Input Sensitivity: 150mV-2.5V 150mV-2.5V 150mV-2.5V
Slew Rate: 13V / Usec 13V / Usec 13V / Usec
Fuse Rating: 100 amp 100 amp 100 amp
Dimensions:

Height: 2.25” 2.25” 2.25”
Width: 9.5” 9.5” 9.5”
Length: 10” 10” 10”

General Information:

Frequency Response: <10Hz to 275Hz
Low-pass Filter: Variable 24db, 77 to 275Hz
Battery Connectors: 2 Gauge
Speaker Connectors: 8 Gauge


CONTROLS AND CONNECTORS

(1) Positive Power Terminals –This is the power feed from the positive (+) terminal of the car’s battery. Use 4-gauge cable (MINIMUM) and good quality terminals when routing this connection. Tighten all connections well to prevent power loss due to bad contact. Route the power cable away from the RCA jacks and speaker cables

(1) Ground Terminals - For optimum performance, use 4-gauge cable MINIMUM! Connect this cable to your battery’s negative (-) terminal or to a secure area of the body in the trunk. *See note below.

Remote Terminal - The amplifier will turn on when 12 volts is applied to this terminal. This 12-volt signal is usually taken from the Power Antenna or Remote wire coming from the source unit.

Speaker Terminals - Connect to speakers using 16-gauge wire (minimum). Running too low of a speaker impedance will cause the amplifier to go into a fault condition.

Crossover Filter – Linkwitz/Riley 24db slope. This control sets the 6db down point of your amplifier.

Gain – Allows input levels between 150mV (max gain) and 2.5 volts (min gain) for full output.

Recommended Fuse – 80 amperes.

Recommended Battery: You should use 1 battery for each pair of amplifiers. If your system uses only 1 amplifier, then the starter battery is sufficient. Note: When you have to parallel 2 or more batteries together always use the same, size, brand and amperage of battery. This will ensure that the batteries charge equally. We do not recommend battery isolators. At 2 or more batteries, you will need to upgrade your alternator. The starter battery should always be upgraded with a high output audio battery.

Note: If you use the chassis as a source for your ground in the trunk, you MUST increase the size of the wire that runs from the front battery to the fender. Remember; 12 volts has to run in a continuous loop and if you do not increase the ground wire up front the voltage/current will be restricted and your system will not play to its fullest.


Price:

350.00


Shipping and Miscellaneous Item Information:

free


Item Pictures:
[I]http://i1048.photobucket.com/albums/s373/crxjim29/20130203_145806_zps8da01fb5.jpghttp://i1048.photobucket.com/albums/s373/crxjim29/20130201_125000_zps917f7258.jpghttp://i1048.photobucket.com/albums/s373/crxjim29/20130203_145748_zpse17301bd.jpg
Literally exactly what I've been looking for! I want this. Trades? I got lots of stuff..pm me

Spooney
02-03-2013, 06:05 PM
The recommended fuse is 80 amperes or 100amp according to the description

So is that 2000@1ohm a Max or rms rating

13.8v x 100a = 1380watts before the fuse blows

Or am I missing something?

Does anyone know if this does rated as I wouldn't mind picking it up

I wouldn't worry too much about the fuse rating . Fuses can handle way more than their rating for short periods of time. Sure you could slap a 200 amp fuse on there but the minute you have a problem the amp is going to be burning up before the fuse does. These amps are beast. Small footprint and crazy efficient. One of the few companies still doing things here in the US. She will do rated .

crxjim29
02-03-2013, 06:14 PM
thanx guys,yes this amp is very efficient!i had a sundown 1200rms and it seemed liked it pulled more than this amp at 2000rms,so yes it is an awesome amp,good to see people that know bout these bad boys!i remember when they first came out or when i first heard of them my buddy got a d200hc,it was the loudest most efficient amp i have ever heard back in 1995,and they still are a very strong!!

GVP
02-03-2013, 06:33 PM
Trade u a d200hc plus cash

ace_800
02-03-2013, 07:00 PM
trade for an Exile 2400.1+cash? Rated at 2400@1, 1600@2. Does more.

crxjim29
02-03-2013, 08:58 PM
sale pending

CerwinVega_Fan
02-04-2013, 12:20 AM
Got to love mmats!

jprophet
02-04-2013, 12:57 AM
mmats is still some of the most reliable efficient amps around ive had my 3500d 5 years never clipped it once and i beat it hard , rock solid in my opinion

jprophet
02-04-2013, 01:02 AM
*i beat it hard........priceless

TheUnderFighter
02-04-2013, 03:46 PM
The recommended fuse is 80 amperes or 100amp according to the description

So is that 2000@1ohm a Max or rms rating

13.8v x 100a = 1380watts before the fuse blows

Or am I missing something?

Does anyone know if this does rated as I wouldn't mind picking it up

Mmats is stupid efficient, and they don't pull as much current. This is a great deal on the best 2k amp you will ever own.

GreekBrotha8
02-05-2013, 10:33 PM
My new amp :) :) :)

crxjim29
02-06-2013, 12:17 AM
My new amp :) :) :)
congrats brotha enjoy!you got a nice 1,and thanx to all for your help and info on how to list this thing,hope to bring more to the table,i buy and sell alot,thanx alot guys!!
this sure beats ebay!lol

---------- Post added at 12:17 AM ---------- Previous post was at 12:16 AM ----------

Sold!!