View Full Version : bandpass through rear deck
02-02-2013, 09:55 PM
I am going to be redoing my box here before too long and thought about going with a bandpass ported through the rear deck. I had a factory 10" in the rear deck so there is a nice open space anyways. I have a pair of RE s-e-x 10"s getting about 800~ watts rms each.
I haven't seen any bandpass/trunk builds so I was wondering if anyone has experience here? I would probably end up with really close to 2:1 ported/sealed and I have a 6" aero I'd be bringing up through the rear deck.
can work nicely if you do it right good sir ;) design it properly your good to go!
edit: driver has a decent QTS value so the box shouldnt be TOOO big
specs to help you out
Electrical Q Value (Qes): 0.46
Mechanical Q Value (Qms): 4.4
Total Speaker Q Value (Qts): 0.42
Free Air Resonance (Fs): 26.6 Hz
Equivalent Compliance (Vas): 31 liters
One-Way, Linear Excursion (Xmax): 18 mm
Efficiency (SPL 1W/1m): 83.2 dB SPL
Effective Piston Area (Sd): 310 cm2
DC Resistance (Re): 2.8 ohm
Nominal Impedance (Znom): Dual 4 ohm
Thermal Power Handling (Pe): 600 W
Force Factor (Bl): 17.7
02-02-2013, 10:13 PM
I've never designed a bandpass but my buddy has done a ton and has quite a few trophies ans titles under his belt but he always does walls and suv's. I was thinking like .6~ sealed each and like 2-2.5 ported.
02-03-2013, 07:17 PM
Does that 1.25/2-2.5 sound good? I hear a lot of people say 1:2 sealed/ported but...