PDA

View Full Version : Clarion EQS746 Tuning



CaddieJapan
01-27-2013, 04:59 AM
Just ordered one of these for my new install. I have the van torn apart right now, installing a new alarm, running more 0 awg etc, basically getting everything in order to fire up these two Xcons. In the process of reading I ordered a Clarion 746 EQ. Can anyone shed some light on setting this up and tuning it? I will have to connected to a Pioneer 9400BH if that helps. Thanks.

05fronty
01-27-2013, 07:50 AM
be careful with that eq. it is good but will send a clipped signal real quick. signal out is like 8volt i think

pickup1
01-27-2013, 09:34 AM
Won't be able to do much until everything is installed...then just mess with it..does it have an input gain?

keep_hope_alive
01-27-2013, 09:48 AM
you don't gain anything by adding the EQS746 to your DEH-P9400BH. it will just add noise.

CaddieJapan
01-27-2013, 04:33 PM
you don't gain anything by adding the EQS746 to your DEH-P9400BH. it will just add noise.

Awww dang that *****. I was hoping to run my mids and highs with it.

keep_hope_alive
01-27-2013, 09:28 PM
Awww dang that *****. I was hoping to run my mids and highs with it.

it's not powered, you still need to use an amp or the HU amp. that EQ would just go between the HU and the amp, but won't provide any more usefulness since the HU is full featured.