PDA

View Full Version : 30" x 2" Square port?



Drummer65
11-08-2012, 07:37 PM
Hey guys

Im helping a friend with a build for a DD 9515g

Box is 4 cubes and the slot port would be 30" x 2" for a total of 60 square inches of port"

My question is is the 2" of port sufficient in height or will air have trouble escaping the port? Do i need to do like 20x3" or 15" x4"?

It would be much easier to do the 30"x2"

Thanks

RangerDangerV2
11-08-2012, 07:40 PM
nope. you will build too much compression with such a skinny port. it will mess with your tuning and it will create port noise.

bhsdriller
11-08-2012, 07:41 PM
too much skinny

Drummer65
11-08-2012, 07:50 PM
Yeah figured I would get port noise

Okay so ill go with 15"x4" then. Does 60" of port area sound right for a DD 9515? About 2.5k watts going to it.

I had about 95" for two on my past setup

mlstrass
11-09-2012, 01:40 AM
16^2 for DD's is the norm for daily.

1:9 ratio for slot ports, so your 2x30 is not even close...

UnderFire
11-09-2012, 01:46 AM
I don't think That's how the calculation works, Try downloading Torres box calculator, it gives you the real port area as well as the square inches per cubic foot automatically.

kushy_dreams
11-09-2012, 02:33 AM
The recommended DD box system uses 16sq in of port for every cube so you could go a little bigger to ~64sq in of port area.

Canaan
11-09-2012, 02:58 AM
Hey guys

Im helping a friend with a build for a DD 9515g

Box is 4 cubes and the slot port would be 30" x 2" for a total of 60 square inches of port"

My question is is the 2" of port sufficient in height or will air have trouble escaping the port? Do i need to do like 20x3" or 15" x4"?

It would be much easier to do the 30"x2"

Thanks


No...no..no...please...NO.

If you are thinking about a 30"x2" port for a DD9515G, just abandon your box design NOW!!!!!

Please, let me help you. PLEASE!
.
.
.
.
First off:

What vehicle are you using?

Second:

What is your max measurements for the enclosure?

I will have other questions, but you CAN NOT answer them without first answering these first 2 questions.

Drummer65
11-10-2012, 03:35 AM
No...no..no...please...NO.

If you are thinking about a 30"x2" port for a DD9515G, just abandon your box design NOW!!!!!

Please, let me help you. PLEASE!
.
.
.
.
First off:

What vehicle are you using?

Second:

What is your max measurements for the enclosure?

I will have other questions, but you CAN NOT answer them without first answering these first 2 questions.

Yeah i'm not doing a 30x2 port

I'm going with 4 cubes, 32hz with 60" of port area (15" x 4")

Here is the box design. Sub facing up port is facing up on drivers side. Sub will be on top on the right side or directly in the middle of the box.

Max dimensions 31" wide, 27" deep. 12" height towards the trunk lid and max 18" where the seats will be.

Car is a 2004 Hyundai tiburon, so its a hatch.