View Full Version : Kicker cvt 10 to port or not?
10-26-2012, 11:29 AM
So I am building a sub enclosure for my 05 f150 supercrew cab, it is .88 cubic feet down fire single 10" cvt 2 ohm sub powered by zx400.1 at 2 ohms and I'm debating on making it a sealed with poly fil or ported with poly fil or no poly fil. I'm going for sq and SPL too, just a nice low but clean bass.
Kicker recommends .8 to 3.0 cubic feet for sealed and 1.25 to 1.75 cubic feet ported and I have .88 cubic feet should I listen to these recommendations or will ported make this sub sound great?
Also not sure of hz I would need to tune it too?
All help is greatly appreciated!!
10-26-2012, 11:42 AM
if you are not dead set on that sub, there are a lot of 8's that would shine in a ported box that size, and can be tuned pretty low. sundown audio, digital designs, cadence, skar, just to name a few.
---------- Post added at 10:42 AM ---------- Previous post was at 10:42 AM ----------
tuned as low as 30-32hrtz.
10-26-2012, 11:49 AM
Thanks for the quick reply and help!
Yes I'm pretty set cause I've purchased it already. But what would you recommend on the set up I have?
10-26-2012, 12:00 PM
sealed boxes can be ok, i used to use them. then i got my first ported box, a 12inch rf t212 @ 33hrtz...never doing sealed again. some guys on here will rag on the kicker subs, but they are ok, especially if you already have it. some of the subs i mentioned are less than $150, but anyway, if you are restricted on space you can only work with what you have. as far as poly-fill, i can't speak on that, don't know enough about it. i think it has something to do with the sub "thinking" it is in a larger enclosure, something about slowing down the sound waves and whatnot.
10-26-2012, 12:11 PM
Okay I guess ill try it sealed with poly fil and then without, and see the difference.
And maybe try to port it.
Thanks for the help and input
10-26-2012, 12:13 PM
Just go sealed. If you go ported you will have to displace the port and end up with an enclosure that is far to small.
10-26-2012, 12:20 PM
^^^what he said^^^ it will still do what is it supposed to do.
10-26-2012, 12:27 PM
Sounds good guys, sealed it is. I appreciate it!
10-26-2012, 12:28 PM
cvt's aren't supposed to be ported, read the owners manual....derp