PDA

View Full Version : help with s shaped port



fatboyracing
10-04-2012, 12:40 PM
Hopefully someone can help or explain this to me. I need to build a box and the depth can not be real big I will not have the room to put the sub and the port if I do it as a L shaped port.

How do I plain a s shaped port I thought it would be 6 common port walls but that is not it errors out.

Do I still just do the 3 common port walls and just increase the port length and not worry if it is l shaped port or s shaped

I hope what i am asking makes sense

winkychevelle
10-04-2012, 12:58 PM
Just pay a few bucks to a box designer in here. Cheap and they know what they are doing. After talking with moblenclosures a bit that's prolly who I would go with

fatboyracing
10-04-2012, 01:42 PM
Just pay a few bucks to a box designer in here. Cheap and they know what they are doing. After talking with moblenclosures a bit that's prolly who I would go with


Thanks But I would rather learn and understand rather not know and pay someone.

BrownVanMan
10-04-2012, 01:49 PM
aero port?

fatboyracing
10-04-2012, 02:02 PM
No what I am talking about is like zig zagging or what ever


aero port?

double 07
10-04-2012, 02:28 PM
It counts as 3 common walls.....just remember to 45 the corners, keep port same width all the way through and measure length of the port down the center...

skylineTT
10-04-2012, 02:34 PM
What double 07; said.

fatboyracing
10-04-2012, 02:41 PM
thanks