PDA

View Full Version : 45 for 3" port



av83
10-01-2012, 12:07 PM
I need to know how how wide the the port 45 should be in 3" slot port.

BlactimusCrime
10-01-2012, 12:10 PM
try to keep the port consistently 3" wide

av83
10-01-2012, 12:19 PM
try to keep the port consistently 3" wide

that's what i'm aiming for, should be the same for all 3" ports... you know it off hand so i can just measure and cut?

BlactimusCrime
10-01-2012, 12:22 PM
that's what i'm aiming for, should be the same for all 3" ports... you know it off hand so i can just measure and cut?

just draw it out on a piece of paper and measure. its not hard.

kushy_dreams
10-01-2012, 12:25 PM
geometry is your friend, its not very hard at all

av83
10-01-2012, 12:26 PM
just draw it out on a piece of paper and measure. its not hard.

duh. :emb:




I must need more coffee. I feel like a ******* now, lol....

BlactimusCrime
10-01-2012, 12:31 PM
It kinda looks like the long side of your 45 piece should be about 2.5", but thats a guesstimation, Double check it

BlactimusCrime
10-01-2012, 12:37 PM
It kinda looks like the long side of your 45 piece should be about 2.5", but thats a guesstimation, Double check it

Confirmed.

And the back should be a bout an inch

av83
10-01-2012, 12:43 PM
Thanks Blactimus!

av83
10-01-2012, 12:45 PM
geometry is your friend, its not very hard at all

I know. I still don't know why I didn't just grab a piece of paper.... internetz made me lazy, lol