PDA

View Full Version : How can i tell how much volume or cu ft is effected with port.

Rc26142
09-03-2012, 01:12 AM
26535753How can I determine how much space or area a port takes up in a sub box as far as volume?
Is there a certain calculation, do I add or subtract volume from the box. Any help would be appreciated.
Ron

NoLoud4U
09-03-2012, 01:13 AM
You might want to rethink that design

IonRL205
09-03-2012, 01:14 AM
You measure the port and then use simple math to figure it out. But if the box is being built, then you should already know what the volume for your port is.

Rc26142
09-03-2012, 01:57 AM
You might want to rethink that design
Can you elaborate? What would you change

Rc26142
09-03-2012, 01:58 AM
Box is being built, but not by me. I was asking the question for my own knowledge.

RangerDangerV2
09-03-2012, 02:04 AM
Can you elaborate? What would you change

everything.

Rc26142
09-03-2012, 11:51 AM
everything.

Thanks for the reply, I'll keep that in concideration when I have a vehicle that does not require the need for a wedge configured box.

RangerDangerV2
09-03-2012, 11:53 AM
Thanks for the reply, I'll keep that in concideration when I have a vehicle that does not require the need for a wedge configured box.

and your point is.....

Rc26142
09-03-2012, 01:12 PM
About the same as your comments, no worries its cool. Not everyone is up to the challenge or has the knowledge to make a wedge box sound decent.
Thanks for the help

Kangaroux
09-03-2012, 01:53 PM
Box looks fine to me...and OP just your simple L x W x D will tell you port dimensions. If you use an aero port it's pi * d * length. Make sure to divide by 1728 to see what it is in cubic feet