PDA

View Full Version : 2011 Sonata SE - MTX9500, Orion P6.2's and a false floor



TooLowTooGo
08-26-2012, 11:37 PM
It's been awhile since I've been on here - actually its been about 5 years since I even had a subwoofer in a vehicle. I bought my Sonata a little over 2 years ago, since then of course I haven't been so much of a bass head you could say. But it's time for me to have a little bump again...

What I have left over from my competing days:
PA 3000DB
PA 6004
MTX 9512 Dual 4ohm
(4) Orion P6.2's - only going to install 2
Areoports :yumyum:

I finally got some time this weekend to begin this project. So here's my idea, I am going to keep the stock headunit by putting an Audiocontrol LOC in. Get some KnuKonceptz wiring for the power/ground, build the box, build a false floor so I can still get to the spare tire, and get this done in 2 weekends, haha doubt it.

Here is my mock up design.
http://i.imgur.com/GK0yS.jpg

TooLowTooGo
08-26-2012, 11:39 PM
False floor fitting. Carpet to come later.

Closed
http://i.imgur.com/qx2Yv.jpg

Open
http://i.imgur.com/lzA3p.jpg

TooLowTooGo
08-26-2012, 11:41 PM
Box
http://i.imgur.com/asehT.jpg

Seeing if I have room for a port, I'll make it work haha.
http://i.imgur.com/CU74U.jpg

TooLowTooGo
08-26-2012, 11:43 PM
Test fit without interior
http://i.imgur.com/qQCfp.jpg

Test fit with carpet and floor mat
http://i.imgur.com/MQp1s.jpg

kushy_dreams
08-26-2012, 11:54 PM
Box seems a little small, what are the specs for it?

TooLowTooGo
08-28-2012, 12:36 AM
Box seems a little small, what are the specs for it?

After port/sub displacement, looking around 1.75 cubes ported @ 35hz. I have no idea how this sub is only .19 but whatever, not going to question MTX.

kushy_dreams
08-28-2012, 03:30 AM
.19 is enormous for a 12, still pretty big for even a 15

cyn
08-28-2012, 03:42 AM
.19 is enormous for a 12, still pretty big for even a 15
RE HC .2 displacement on the 12"... but yeah that sub doesn't look that big on displacement

TooLowTooGo
08-28-2012, 10:59 AM
Yeah .19 is a lot for a 12, but the sub fills up 1/3 of the box... That's why it boggles my mind.

TooLowTooGo
08-28-2012, 11:37 PM
Resin inside. I just attached the top of the box and now need to resin the parts that weren't covered.
http://i.imgur.com/BDz2w.jpg

Size of the sub next to a water jug. The port hasn't been cut to size yet.
http://i.imgur.com/OLhBj.jpg