View Full Version : Carver KLW xa 22
08-25-2012, 03:10 AM
Is there anyone who can help me?
I search for a couple of pictures ( 2 - 3 ) from the print of the remote controle from the KLW XA 22.
I have also a KLW XA22 but no remote controle.
So if i have these pictures , mayby i can make a remote by myself....
You where very helpfull if you can.
Kind of regards from Holland
08-25-2012, 07:08 AM
I will take a few before i send mine...well Daves off...give me a few....
08-25-2012, 08:10 AM
Tnx it will really help me to make a remote. I now it's only a potentiometer and a switch........
08-25-2012, 08:37 AM
i wonder if an audio control knob would work...
08-25-2012, 08:51 AM
A couple of mounths ago i buy a KLW XA 22. But the guy send me only the baseunit of the KLW XA 22. I send many emails to him but with no responce.
I look at the pictures on the internet from your post, so i think the remote is nothing more than a potentiometer (knob) and a switch ....... and a cable to contect both parts together...... :idea:
08-25-2012, 08:55 AM
08-25-2012, 09:26 AM
Many thanks, i will try it, Good pictures!!
I see from rj 12 connector a wire to middle connector of potentiometer > from left connector of potentiometer to front connector of the switch. And middle connector of the switch to rj12 connector. And a potentiometer from 2K Ohm
Kind of regards, from Holland :-)
08-25-2012, 09:39 AM
Glad i could help...
08-25-2012, 10:52 AM
Great job, It's works. I shame to ask you if it's possible to send/post the manual also????? Strange thing is that only 1 channel works as bass resistor and 1 channel works as normal bass.
08-25-2012, 10:54 AM
the manuals shown were for the cross overs...did not come with any...
08-25-2012, 02:22 PM
It works, there was a little problem, with a short circuit in the KLW unit.
Many thanks to Pickup 1 for the pictures.
Pickup 1 is it right that the print on the potentiometer is B2K and not 82K?
Kind of regards ......
08-25-2012, 06:33 PM
Thats what's on the back..
08-25-2012, 06:44 PM
Okę tnx, then are the info on the schematic correct.