PDA

View Full Version : First SA-8 v.2 Drop-In Kit



sundownz
05-11-2012, 01:15 PM
I have two to build so far -- IIRC this one was a drill slip into the surround. In any event -- just finished the first one and it looks neat so I took a few photos :

http://www.sundownaudio.com/misc/protos/SA-8/v2_Version/drop-in/CIMG6244.JPG

http://www.sundownaudio.com/misc/protos/SA-8/v2_Version/drop-in/CIMG6245.JPG

http://www.sundownaudio.com/misc/protos/SA-8/v2_Version/drop-in/CIMG6246.JPG
* This is where it really varies from our other kits. The spider spacer along with dual triple joint rings. You cannot see the 2nd triple joint ring but it is in between the spider layers.

http://www.sundownaudio.com/misc/protos/SA-8/v2_Version/drop-in/CIMG6247.JPG

It did take a good bit of time to assemble; which is why these kits are "expensive" compared to our other SA kits.

RangerDangerV2
05-11-2012, 01:21 PM
oooh you should make some with spl coils brah...:yumyum:

sundownz
05-11-2012, 01:22 PM
If someone orders one I will -- we have D1 8-layer flat SPL coils and then D2 and D4 4-layer round SPL coils in stock.

ace_800
05-11-2012, 01:39 PM
Could one of these recone's fit a V1?

sundownz
05-11-2012, 02:38 PM
Could one of these recone's fit a V1?

They cannot directly bolt on.

The basket bolt pattern is much wider on the v.2

RangerDangerV2
05-11-2012, 03:24 PM
sundownz you should start makin the saz3500 with dual inputs.... just sayin.

sundownz
05-11-2012, 04:13 PM
sundownz you should start makin the saz3500 with dual inputs.... just sayin.

Funny you should say that... keep your eyes on the 2012 amp thread.