PDA

View Full Version : Port question



DDtC
04-27-2012, 09:04 PM
When doing a center port do you split the port length at the bend? Say I need 30 inches of port length, if my bend is at 20 inches is each side 10 inches or 5?

Kangaroux
04-27-2012, 09:09 PM
You keep the length the same but you cut the port area in half. So if your port is 5" x 10" x 30" long, it will be 30" long from the start of the port to the end of each fork. But the port will go from being 5" x 10" to 2.5" x 10" once it splits

Buck
04-27-2012, 10:28 PM
It would be 10.