PDA

View Full Version : Box I modeled on Autodesk Inventor for extended cab silverado



skylineTT
03-08-2012, 05:04 PM
A customer who bought one of my subs needed a box also so I modeled on up for him that will put him around 1.25 ft^3 with aero port length to desired tuning. I modeled all of the pieces and made an assembly, then took pics of the build steps for him. Also took pics of the individual pieces with dimensions for his cuts.

He has all of the right tools so none of this should be too much of a problem. It is going under the seat with slight transmission hump in the middle.

http://i69.photobucket.com/albums/i57/all-names-were-taken/Step1BottomPlates.jpg
http://i69.photobucket.com/albums/i57/all-names-were-taken/Step2BridgeRisers.jpg
http://i69.photobucket.com/albums/i57/all-names-were-taken/Step3Bridge.jpg
http://i69.photobucket.com/albums/i57/all-names-were-taken/Step4Back.jpg
http://i69.photobucket.com/albums/i57/all-names-were-taken/Step4Sides.jpg
http://i69.photobucket.com/albums/i57/all-names-were-taken/Step6FrontPlate.jpg
http://i69.photobucket.com/albums/i57/all-names-were-taken/Step7TopPlatewithsubondriversside.jpg

The 3" hole and 10" hole are just placeholder dims. He will figure out the OD of the aero that he is using and cutout dia. of the sub to make those right.

ShawnT
03-11-2012, 06:42 PM
This would be a crew cab box. The extended cabs are a little different.

Thanks for everything Hector, going to build it now.:)